Part # PL0183
Dimensions 31" L x 11.5" W x 6.5" D
Alternate Part #'s 59003000, DEX6000DA, FC-9350, R0359100, V38-193
Time to Replace Your DE Grids?
Our DE Grids are used on the most common pool filters including American Products®, Pentair®, Hayward® & Pac-Fab®. Most DE Filters will require 7 Full Grids and 1 Partial Grid. Typically DE grids last about 5 years so if it has been longer than 5 years then now is the time to replace your DE grids.
Things to Consider When Replacing Your DE Grids
Note: Collar has open slot (2 notches). Length is measured from one end of the grid to the other (collar not included).
Disclaimer:
All manufacturers’ names, brand names, trademarks, images, symbols, descriptions, and part numbers are used herein for reference purposes only.
how many full Hayward de filter grids do i need 11 1/2" , 7 ? do i need a partial grid also 9 1/2" ?
Reply
Hayward DE filters will require 7 Full girds and 1 Partial grid. If you have a 60sq ft. filter you would need 7 of the FG1005 and 1 of the PG1905. If you need to get the whole set you can get the FG1005PACK.
Reply
Which grids do I need for a Nautilus NS 36?
Reply
Hi Tom, Here is the Complete Nautilus NS36 Grid Assembly you would require. If you only require the DE Grids then the FG1003PACK DE Grid Pack is what you would need.
Reply
can you cross reference a Purex D. E. Filter Grid. Model # SMBW 2060 filter area is 60 sq ft
Reply
Hi Teresa, The 30" Purex Grid (074925) would be the correct grid(s) for the SMBW 2060 DE Filter.
Reply
1 to 2 hrs
Nut Drivers, Adjustable Wrench
1. Turned pump off.
2. Open air relief valve on filter.
3. Moved multiport valve to closed setting.
4. Removed filter plug to drain water from filter.
5. Removed nut from filter and ring.
6. Removed ring and pulled upper filter housing off of lower filter.
7. Removed large o-ring, inspected and hosed off.
8. Lifted filter via manifold supports and off inlet tube.
9. Removed support nut and manifold.
10. Remove 8 grids.
11. Wash out filter.
12. Install 8 new grids to base plate and manifold.
13. Reinstall gasket and lubricate.
14. Place top filter housing back onto lower filter housing
15. Install support ring and tighten nut per manual.
16. Place multiport valve in filter mode.
17. Make sure pump is primed.
18. Close air relief valve when streaming flow occurs.
19. Add new DE to skimmer per manual procedures.
20. Set pressure indicator to clean pressure mark.
21. Done.
2 to 4 hrs
Socket Set, Wrench Set
Opened up the filter, cleaned off the grids, removed the filter. Cleaned in TSP then soaked
grids in 1 gallon of muriatic acid and 15 gallons of water for 2 hours doing 4 at a time
rinsed the grids reassembled and installed new filter. Added DE filter material and all good.
1 to 2 hrs
Screwdriver, Socket Set
1 0
The pressure was increasing past 30 shortly after turning the pump on. The current filters looked ok but after i replaced them the pressure was steady at 13. Inyo says it takes 7 filters but the correct number is 8. They dont give you the shorter one near the inlet
1 to 2 hrs
Socket Set, Teflon o-ring grease
1 0
1. First I checked the Inyo online forums and videos. That confirmed that the problem was probably a torn filter grid cover.
2. Also using the Inyo video guides, I dismantled the DE filter and found a small tear on the edge of one grid. Ordered a replacement grid AND the body O-ring, which was also worn.
3. Replaced the leaking grid, again after watching a video linked to INYO. This is a tedious process with a Hayward filter, no way to speed make it easy, unless Hayword or INYO could make a template to hold the grids in place while reattaching the upper manifold.
4. Lubes the O-ring, reassembled the filter and loaded the filter with DE. It all rem,ained in the filter. No more leaks!
The Most Helpful Review
15 1
(5 out of 5 stars) De Grids
Reviewed By: vivogram from Bridgeview, Il ()
Pros: exactly what we needed
Cons: none
we looked all over for the parts for our filter. We have had it since 1985! the description off the parts as well as the fast shipping was awesome
Was this review helpful to you?
The Most Recent Reviews
(5 out of 5 stars) Very affordable!
Reviewed By: Inyo Customer ()
Very affordable replacement grid.
Was this review helpful to you?
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
great quality. a better replacement than the pentair brand in my opinion.
Was this review helpful to you?
(5 out of 5 stars) Drop in replacement for Pentair
Reviewed By: Inyo Customer ()
Perfect fit and performing well.
Was this review helpful to you?
(5 out of 5 stars) Pentair 60 Sq ft DE filter
Reviewed By: Inyo Customer ()
Great prices and product was as described. Fits perfect Pentair FNS 60sq ft DE filter
Was this review helpful to you?
(5 out of 5 stars) grids
Reviewed By: Inyo Customer ()
all good
Was this review helpful to you?
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
Good quality!
Was this review helpful to you?
(5 out of 5 stars) Much cheaper to buy on this website
Reviewed By: Inyo Customer ()
I use these all the time. It is much cheaper to buy on this website rather than our local retail store.
Was this review helpful to you?