Finding correct O-Rings

My orginal pump was a Century Pump, my replacement pump is a U.S. Motor Pump.  On the U…S. Motor Pump I cross referenced the Cat Number ASQ-165 and 1081 Pool Motor from the company " U.S Motors".  This produce info regarding a Paintar Pump. So I am assuming that my replacement pump can use Paintar Parts and I AM LOOKING FOR THE O-RINGS.

Specifically, the O-ring that goes around the shaft. 2 to 3 inches circumfrence.     THANKS FOR THE HELP.  bob

Hi Bob, the seals are specific to the pump housing and not the motor, so we need the pump model information and not the motor model information to recommend what you need (motors are used on a number of different pumps, so the motor model doesn’t tell us what we need to know).  See this guide on Finding the Tune-Up Kit for Your Pool Pump to help get you started, or send us pictures of the pump housing (and any labels you may find on it) and we will try to identify it for you.

The Tune-Up Kits for the Pentair pumps are located here, but note that the Tune-Up Kit for the Challenger pump is only for the CH series and not the CF series of pumps (the GOKIT73 is for the CF pumps but is not on that webpage).

Hello Tuesday, 4-19-2022

Pump model from Pump Housing is PINNACLE PENTAIR PRODUCTS.  PFII-P1-  1 1/2

1/2. /KO7

34-2352

Replacement pump model is U.S .MotorsC55CXJWN-2193. cat No.ASQ165 been replaced withUSQ1152. (maybe)

thanks for the help.     I do not have a solution

Please advise I still do not have a solution

Perfect - thank you for the information!  We would recommend the GOKIT24 Tune-Up Kit for your Pentair / Pac Fab Pinnacle pump.  The Tune-Up Kits contain all of the o-rings you will encounter as well as a new motor shaft seal to ensure a leak-free installation.

The individual parts for your pump are on this webpage if you only need the single o-ring.

Thursday. April 20, 2022

Hello,

I need the o-ring that goes around the silver shaft it is on the outside of the 48 Y-frame

Pump model from Pump Housing is PINNACLE PENTAIR PRODUCTS.  PFII-P1-  1 1/2

1/2. /KO7

34-2352

Replacement pump model is U.S .MotorsC55CXJWN-2193. cat No.ASQ165 been replaced withUSQ1152. (maybe)

I’m sorry I didn’t recommend the right part for you.  The only item that goes around the shaft of the motor is the water slinger, and that is included with most of the new motors.  It is item #19 on this diagram.  Is that what you are looking for?