New 2 speed pump motor trips breaker on high speed only after changing wiring from one speed

I have an Aqua Logic controls and for some reason with the new 2speed motor the high speed causes the circuit breaker to trip.  Since it was necessary to change the wiring I am at a loss to why this is happening ( it must be the wiring or the motor)

We’d be glad to assist you. Could you post a picture of how the pump is wired within the control box as well as how it’s wired to the back of the motor?

Check out our guide titled “How to Wire a 2-speed 230V Motor to a Hayward Pro Logic System”. The steps are very similar to the Aqua Logic system.