New booster pump tripping the breaker

  • 75 Views
  • Last Post 28 January 2021
rktexas posted this 25 January 2021

I replaced my Century B625 3/4 hp booster pump motor with an exact replica (same part number). After hooking everything back up, I flipped the breaker switch and one of the live wires (attached with a wire clip) popped off the tab and the breaker tripped. I disconnected, then reconnected, all the wires (1 ground wire and 2 live wires) and tried it again...same result when I flipped the breaker switch. Is the issue with the motor or could it be a breaker box problem?

Order By: Standard | Newest | Votes
InyoRob posted this 26 January 2021

We'd be glad to assist you. Could you post a picture of the wiring terminal so we can see how it is currently wired?

rktexas posted this 26 January 2021

InyoRob posted this 28 January 2021

One of your hot black lines should be connected to terminal 1 and the other hot black line should be connected to terminal 6. If the breaker is still tripping, make sure the wires have a good connection at the breaker. After that test the breaker with a multimeter. If the breaker is ok, contact the retailer who sold you the motor. It may be defective.

Close