Pool Light bulb replacement

  • 30 Views
  • Last Post 06 May 2019
  • Topic Is Solved
GregoryK posted this 06 May 2019

My in-ground liner pool light bulb needs to be replaced. The buildiner failed to leave enough slack on the cord to remove it entirly out of the water and the light is 12" under water. How can i replace the bulb and not drain the water to do this?

Order By: Standard | Newest | Votes
GregoryK posted this 06 May 2019

OK. i will check when i get home tonight.

  • Liked by
  • InyoRob
InyoRob posted this 06 May 2019

The only way to replace the bulb, in your case, will be to drain the water below the light fixture.

GregoryK posted this 06 May 2019

what if i replace the whole fixture with new cord and all?

InyoRob posted this 06 May 2019

You could replace the entire fixture without having to drain the pool.

The pool was drained in the video below but it's not necessary.

 

GregoryK posted this 06 May 2019

How do i know what fixture to order? it has a single screw at the top.

InyoRob posted this 06 May 2019

There should be a sticker on the back of the fixture. Are you able to pool it away from the niche enough to see the back of the light?

Close