Uni-Bead Liner

Pool Construction
1

Hi, I am replacing the liner on our above ground pool and purchased a Uni-Bead Liner.

When we setup the pool again, the bead receiver strips do not butt against each other…and or them to fit around the top, we had to space them with an approximate gap of 1" between them.

Will this work if we use the “Beaded” part of the this liner with the “gaps” or will it cause it to pull out?

OR, can we use the “j hook” part of the liner? And if so, do we put the receiver strips over top of the “j hook” part over the wall?

Thank you or your help.

2

My suggestion would be to remove the bead receiver strips and use the j-hook part of the liner. It will be a much easier install and you don’t have to worry about the liner popping out of the track.

3

OK, thank you very much!

4

You’re welcome. Good luck!