By Seit
Part # NA722
Dimensions 3.5" L x 2.5" W x 2.5" D
Alternate Part #'s 57-555-1015, APC12100M3, HAL104020
POOL & SPA REPLACEMENT LIGHT BULBS
Specially designed to keep your pool well lit this season. Our bulbs are made with thicker filaments and glass to last longer. Heavy duty heat shielding prevents damaging heat build-up and prolongs the bulb's life.
* Dimensions may vary slightly
POOL & SPA LIGHT LENS GASKETS
Remember when replacing your pool or spa light bulb it is very important to replace the lights lens gasket. After long use, heat, and harsh chemicals, the old gasket is probably compressed, and if it doesn't fail immediately, it might fail before the next bulb change. Click here for Pool Light Lens Gaskets
For additional pool & spa light bulbs
My bulbs burn out after a few hours of use. What would cause this?
Reply
My first guess would be to check the voltage. If you are getting anything more than 12v to the light, it will run hotter and burn out quicker.
Reply
Hello,
Is there a LED ( white or color changing) replacement for this bulb.
Thank You
Mike
Reply
Hi, Mike. In order to confirm, I will need to know the make and model of your existing fixture. We do not carry a universal LED bulb, they're only compatible with specific fixtures.
Reply
is there an led model for this. I have a pentair series 7810xxx also says use with model 7824xxxx, 792066xx fixture housing if that helps.
Reply
Keith, no, there is no LED replacement bulb for your Pentair Aqualight fixture. You would need to replace the whole light fixture. We offer the PureColors LED Bulb & Pentair SpaBrite Spa Light Fixture Kit 120V 50' Cord - PL5861 as a replacement fixture for your existing light.
Reply
I have a Hayward SP-580 Series Underwater light fixture that is 12 volt 100Watts. Is there an LED bulb available for this fixture?
Reply
Hi John, Is your light used in your pool and not spa? If so and it measures approximately 10-5/8" in diameter then you will require this 12V Pool Replacement LED Bulb Color Changing if you have the smaller spa light for the light fixtures roughly 5-3/4" in diameter then you will require this 12V Spa Replacement LED Bulb Color Changing
Reply
Thank you.
Reply
Less than 1 hr
Screwdriver, Wrench Set
per your video I first turned off the circuit breaker. I then remover the light fixture and placed it on the pool edge.
I disassembled the lens from the fixture, the gasket was in bad shape it had started to deteriorate.
I ordered a new 100w, 12v bulb and gasket. when the new bulb and gasket arrived I assembled them and
reinstalled them per the video. thanks to your video the job was easy since I had never done this before.
