$108.99

Qty:

By Jandy


Details

Top

Part # 7790

Dimensions 15" L x 0.2" W x 0.2" D

Alternate Part #'s 6848, JDY3015097, 59-295-1102, JDY-301-2839, JND7790

Product Description

Temp Sensor Kit Gray (Air/Water/Solar) 15 ft cord.

Top

?     Asked on 3/11/2011by Guest

Does this sensor connect to the control box with two or three wires?
 Reply

A  Answered on 3/11/2011 by InyoPools Product Specialist Patrick P.

It connects to the control box with two wires; one black and one red.
 Reply


?     Asked on 7/13/2016by Liz

The picture does not show an o-ring on the sensor or a pipe clamp. Does it come with these so I can install it directly in a pipe?
 Reply

A  Answered on 7/14/2016 by InyoPools Product Specialist Matt S.

This temp sensor does not come with an o-ring or a pipe clamp. To install you can buy those separately or use the existing o-ring and clamp from your old sensor.
 Reply


?     Asked on 3/25/2017by charles

Hello, my heater system is the Jandy LXi for a salt water pool. Is the water temp sensor I need to replace called the 7790. My parts book states RO477300. ALso, the location is directly downstream of the pool pump. Do you consider that the optimum location for best readings?
 Reply

A  Answered on 3/31/2017 by InyoPools Product Specialist Andy O.

Hello Charles- The Temperature Sensor (Salt) (R0477300) NO LONGER AVAILABLE REPLACED BY R0456500 is Discontinued and no longer available. It has been replaced by the Lxi Temp Sensor W/sleeve & Gasket (r0456500) 6204-208. Both of these sensors are for the temperature of the water and are installed in the headers of the heat exchanger as seen in this parts diagram: http://www.inyopools.com/parts_jandy_legacy_model_lrze.aspx.
 Reply


?     Asked on 11/30/2017by Ronald j Verhoff

is this a 5k thermistor?
 Reply

A  Answered on 11/30/2017 by InyoPools Product Specialist Lennox H.

Hi, Ronald. This is a 10K thermistor for use with Zodiac or Polaris controllers. 
 Reply


?     Asked on 4/6/2018by Inyo Visitor

My water sensor is not plugged in where do I plug it in at
 Reply

A  Answered on 4/9/2018 by InyoPools Product Specialist Lennox H.

Hi. The sensor is wired to the specific terminal in the Jandy Controller. 
 Reply


Top

Review Summary

 (Average 5  out of 5 stars)
3 Rating
5 star:
 
(3)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)

The Most Recent Reviews