Pentair Heat Pump UltraTemp 108,000 BTU - 460932

$2,579.99

IN STOCK
FREE SHIPPING

Part # 460932

By Pentair Pool Products

  5 Average  

Details

Top

Part # 460932

Warranty SEE WARRANTY CARD

Rebate $200 Visa Gift Card

Product Description

"Extend Your Summer" $200 Visa Gift Card (Valid through September 1, 2017 - December 31, 2018)

UltraTemp ® High Performance Heat Pump


Simply the most economical way to heat your pool and spa. With today's record energy costs, there's never been a better time to invest in a heat pump. Compared to gas, oil or electric heaters, UltraTemp uses just a fraction of the energy to generate the same amount of heat.

An Eco Select ™ Brand: UltraTemp ® High Performance Heat Pumps transfer heat from the atmosphere to the pool or spa, saving up to 80% in energy costs compared to gas-fired heaters. Plus, they are the only heat pumps available that use R-410A refrigerant, EPA-recognized as environmentally safe and clean.

 

  • 100% titanium heat exchanger assures corrosion-free performance for extra long life and value.
  • LCD control board displays an intuitive, menu-driven readout with easy to follow, full word messages - no more codes.
  • AutoSet (time clock over-ride) feature monitors water temperature and turns the water circulation pump on and off as needed to maintain desired pool termperatures
  • Automatic defrost feature senses refrigerant temperature and prevents UltraTemp from freezing, allowing the heat pump to operate at even lower temperatures
  • Compatible with All automated control packages
  • Long-life corrosion resistant plastic composite cabinet stands up to severe climates and pool chemicals
  • Emerson Copeland Scroll Compressor
  • ETL listed for safe operation
  • Thermostatic Expansion Valve (TXV) controls refrigerant flow for optimum effciency and BTU output over a wider operating range
  • Highest effciency available, meets or exceeds existing codes and standards
  • BTU and effciency performance independently certified by the Air-Conditioning, Heating and Refrigeration Institute, AHRI







For More Swimming Pool Heat Pumps

Product Specifications

BTU:
108,000 BTU
Heat Exchanger:
Titanium
Compressor:
Scroll
Phase:
Single
Volts:
230
Hz:
60 Hz
Recommended Breaker Size:
50
Wire Size:
8
Top

?     Asked on 10/8/2018 by Mike

How much room around the unit must be free of shrubs, fences, etc.? Do you have a list of approved installers in or near the 20878 zip code (around Rockville, MD)? How much might a typical installation cost, excluding electrical? Thanks. -- Mike

A     Answered on 10/9/2018 by InyoPools Product Specialist Joe S.

The heat pump must be placed to provide clearances on all sides for maintenance and inspection. 1. At least 24 in. [61cm] access must be available in the front and 24 in. [61 cm] on all the other sides of the heat pump for service and proper air flow, see Figure 2. 2. If the heat pump is to be installed under a cover or under a vertical overhang, the unit must have a minimum of six (6) feet [1.83 m] clearance from the top of the heat pump. 3. Install a minimum of five (5) feet [1.52 m] from the inside wall of the pool or spa unless the heat pump is separated from the pool or spa by a five (5) foot high solid fence or other permanent barrier. Canadian installations require a minimum of three (3) meters from pool water.

?     Asked on 10/29/2017 by Jay

Heater is working, cannot increase the temp. It will decrease temp only.

A     Answered on 10/30/2017 by InyoPools Product Specialist Lennox H.

Hi, Jay. The Autoset Board Bezel Label Assembly - 472734 is probably bad and will need to be replaced. 

?     Asked on 8/2/2017 by Don

How big and amps do I need for about 5000 gallon in ground pool ? My pool company says 96,000 an d are trying to sell me a tropical one for 3000.

A     Answered on 8/4/2017 by InyoPools Product Specialist Lennox H.

Hi, Don. A 5,000 gallon pool depending on the location, desired temperature, and heating rate can use a 50K-100K or higher BTU unit. If they are recommending a 96K BTU unit, that requires like a 50 amp 230 volt breaker. This 108K unit will also be sufficient. 

?     Asked on 5/17/2017 by Lauren

Hello- What size heat pump would I need for a 15,000 gallon inground? We have a deep-end going to 6.5ft and a shallow tanning ledge but in total 15K gallons (15x35).

A     Answered on 5/20/2017 by InyoPools Product Specialist Lennox H.

Hi, Lauren. I would not recommend a unit smaller than a 108/110K BTU unit, you can always use a bigger unit which will heat the pool faster.

?     Asked on 4/6/2017 by

What size heater do I need for an in-ground 18 x 36 25,000 gallons?

A     Answered on 4/6/2017 by InyoPools Product Specialist Scott W.

You would want a heat pump in the 125,000-140,000 BTU range depending on what state you reside in.

?     Asked on 2/28/2017 by jim

how many btu,s do i need to heat a 2114 gallon pool

A     Answered on 2/28/2017 by InyoPools Product Specialist Scott W.

You would be good with the 70,000 BTU model for 2114 gallons, part number 460930.

?     Asked on 12/19/2016 by jm

will this heat pump heat a 288 square ft pool?

A     Answered on 12/19/2016 by InyoPools Product Specialist Adam Y.

Good morning Jim, Before I answer can I have the actual dimensions h,w,dth? to get gallon size. I will be able to give you a better answer.

?     Asked on 7/6/2016 by boden

What year model is this?

A     Answered on 7/10/2016 by InyoPools Product Specialist Lennox H.

Hi Boden, This is a current (2015-2016) manufactured UltraTemp model.

?     Asked on 5/10/2016 by Justin

Is this heat pump compatible with above ground pools?

A     Answered on 5/10/2016 by InyoPools Product Specialist Hector F.

Yes you can use these models for above ground pools as well.

?     Asked on 5/2/2016 by

What is the weight of the unit? What kind of base does INYO or Pentair recommend to put the unit on?

A     Answered on 5/4/2016 by InyoPools Product Specialist Alan M.

Hi, the weight of the Pentair Heat Pump UltraTemp 108,000 BTU is approximately 300lbs. Per Pentair's owners manual, the heat pump would need to  be installed on a level surface. You can use an equipment pad or other materials, like pavers or blocks, as long as the base is stable and will not deteriorate over time.

?     Asked on 6/22/2015 by Yannick

How much for shipping to canada.H7p6e7 zip code

A     Answered on 6/23/2015 by InyoPools Product Specialist Lennox H.

Yannick, We're unable to ship the Pentair Heat Pump UltraTemp 108,000 BTU outside of the continental USA, you will need a Freight Forwarder to get it into Canada.

?     Asked on 5/22/2015 by Scott

Is the Pentair 108,000 heat pump just as quiet as other top brands?

A     Answered on 5/23/2015 by InyoPools Product Specialist Patrick P.

Hi Scott, Yes the Pentair heat pump would be just as quiet as Hayward, Jandy, AquaCal & Raypak.

?     Asked on 5/9/2015 by jay

What is the amp draw on 108000 heat pump?

A     Answered on 5/12/2015 by InyoPools Product Specialist Patrick P.

Hi Jay, I don't have the exact amp draw but do have a bit of information for the required breaker which may helpful. Min. Circuit Ampacity: 42 amps, Recommended Fuse Size: 50 amps, Max Fuse Breaker Size: 70 amps.

?     Asked on 5/4/2015 by Roman

Hello,how long we have warranty if we buy this product and what including and how work this warranty.

A     Answered on 5/4/2015 by InyoPools Product Specialist Andy O.

Roman- The warranty for the 460932 is a 2 years parts and labor, 10 years on compressor parts and labor, lifetime on the titanium heat exchanger. The warranty is only valid if you have it installed by a Qualified installer, and if not Pentair will only warranty the parts for 60 days. Here is the link to the warranty card: http://www.pentairpool.com/pdfs/LimitedWarrantyCard.pdf

Top

Review Summary

  (Average 5 out of 5 stars)
3 Rating
5 star:
 
(3)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)

The Most Helpful Review


The Most Recent Reviews