Part # 372082113
Part # 372082113
Dimensions 15.5" L x 8" W x 8.5" D
Alternate Part #'s 3720821-13
When matching pumps always use AMPERAGE rather than Horsepower. Many times the labeled Horsepower does not accurately represent actual horsepower.
The Executive 56 Frame Spa Pump has an executive wet end designed for 56-Frame motors along with two double-shielded ball bearings with moisture-resistant grease for quieter operation and long life. The dual speed motors have insulated windings for increased efficiency and large, highly versatile 6-1/2" diameter wet end for higher head pressure. A split capacitor (start and run) allows for less energy consumption.
Spa Pump Features:
|Speed||2 Speed (2-Spd)|
|Drain Plug Location||3,6,9 o`clock|
|Suction Connection Type||Male Buttress Thread (mbt)|
|Suction Pipe Size||2-1/2"|
|Discharge Connection Type||Male Buttress Thread (mbt)|
|Discharge Pipe Size||2"|
|Motor Frame||56 Frame Thru-Bolt|
Waterway, a leader in spa, bath, and pool products, provides the reliable Executive 56 pump for a great value. Executive 56 spa pumps are energy efficient and produce clear-cut performance. The wet end of each pump has the ability to rotate, offering an easy, no hassle installation.Specifications
Will this replace a pump #7-193675-01 pump? Ours is a frame 56, HTZ 60, 3450/1725 rpm, 230 volts, 8.8/3.0 volt
Hi Doreen, could you send us a few photos of your pump? Please take a close up shot of the pump label as well as a wide shot of the complete pump to include the pipes going in and out of the pump. To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation.
I have a Century 2 speed pump currently 7-193675-01. Can this pump replace that?
Hi William, for us to suggest the proper seal kit and or pump could you send a photo of a wide shot of your complete pool pump to show the pipes going in and out of the pump? To supply this photo simply click the reply link below and upload your photo. Once we get this photo we can make the proper recommendations.
Need a 2 hp pump with 1.5 inch intake and discharge. Do you sell one like that?
Hello, could you send us a few photos of your pump and motor? Please take a close up shot of the motor label as well as a wide shot of the complete pump to include the pipes going in and out of the pump. To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation.
I need the wiring order, this pump has the numbers 1, 2, 3 or 4 and the other pump in my spa has H, C, and L. So I guess my question is, what wire goes on 1, 2, 3. Is 1 high, 2 common and 3 low.
Hi, Cindy. Terminal 1 is C, Terminal 2 is H and Terminal 3 is L.