Product Description

Model 6HI-HL-240(SS6-42-HL)

240 Volts Single Phase
Especially Designed For Easy, Low Cost Installation

Application

The 6HI-HL-240 unit is ideally engineered for heating permanent or portable baptistries of all types. For use in fiberglass, concrete, vinyl, or any design of baptistry.

Construction Features

• Immersion section of unit made of Incoloy or Stainless Steel, and are bright annealed.
• All heat confined to the formed horizontal section for optimum heat efficiency.
• Cold riser extends to the top of container where control housing is located.
• 3-Conductor cord set with polarized plug included for easy installation and wiring at no extra charge.
• Adjustable vapor-proof thermostat control with temperature range off - 55°F to 115°F (± 3°).
• Hi-Limit cut out switch set at 125°F (±4°).
• Stainless steel mounting bracket also supplied for easy mounting.
• Pilot light and on-off switch provided, indicates desired temperature when reached and breaks circuit when element is not in use. Saves electricity - Saves money.

Notes

• Completely automatic and portable - just plug in 42" Power Cord and operate.
• No cutting or damage to your present container.
• Although portable - your container may be cleaned without removing unit.
• Unit can be suspended in middle, end or side of container.
• No contractors required on standard 6HI-HL-240(SS6-42HL) Models
• The 6HI-HL-240 (6KW) will heat 60 GPH (40° R). A 750 to 1,000 gallon Baptistry can be heated in 13 to 17 hours, or one-half this time 20 degree rise in temperature.
• Heater can be operated on 120 volts, but the wattage power will be reduced to 1500 watts but will only heat 15 GPH (40°R) or 30 GPH (20°R).

THIS PRODUCT HAS A ONE-YEAR MANUFACTURERS WARRANTY, FOR REPAIR ONLY. IT WILL NOT BE REPLACED. TO RETURN THIS PRODUCT PLEASE SUMMIT A RMA FORM TO INYO AND ALLOW 3-4 WEEKS FOR THE MANUFACTURER TO REPAIR.