Part # 5055-11
Manufacturer Code C105-238P
Dimensions 4.685" X 0.35"
Alternate Part #'s 351021150, C105238P, STA1018551
I have a Sta-rite P6RA6G-207L 2HP pump/motor and was replacing the motor when I found the impeller scored. It is stamped C105-238P. I see several with the same number but different letters eg. PB, PEBD. etc. Do you know which impeller is the correct model for my pump/motor. Tks
Hi, Rod. The correct impeller for your model pump is Part #C105-238PDBA.
I am wanting to rebuild my sta-rite max-e-pro p6e6d-205L pump motor, how do I pick the right 3/4 hp motor, impeller, diffuser, o-rings.
I have a Sat-Rite 3/4 hp model # P6E6D-203L pump that has a broken impeller. How does the impeller come off the motor shaft?
Hi Gary, Here is a Guide on How to Remove a Pool Pump Impeller which will walk you through the process.
is c105-138peb interchangeable with c105-238 p
No, the c105-138peb is for the Dura-Glas and the c105-238p is for the Dura-Glas II.
Hello I have a Sta-Rite Model P458E-1561L Code: 1F93M pump and motor that motor is bad and looking to replace it. Also have Pump Impeller #C105-238P I understand it is for a 1Hp uprated motor, but not sure just what that means? lol I still don't know witch motor it will require because nothing is showing for Model P458E-151L so not sure motor will work with pump housing and brackets..And it is also looking like may need new impeller as well, so any suggestions on motor and impeller sets?
Hi Tim C., The USQ1102 will be the correct replacement motor. Up-rate is just a term used for motors that operate at the rated hp. The C105-238P Impeller will also work with the USQ1102 motor, I would also recommend getting the Sta-Rite Max-E-Glas II / DuraGlas II Tune Up Kit.
have impeller for sta rite part#105-137p eb what impeller do I need either a 1 hp or 11/2hp motor
Hi Ron, The 1HP Full/1.5HP Max Rate Impeller (C105-137PEB) would be the correct impeller needed.
I just got my UQC1102 motor to replace my original K48K2PA105C1. Which impeller is right -- C105-238P or C105-238PB? What is the difference or could I use either one? Thanks.
Hi Ed, The UQC1102 is a 1 HP uprated impeller so you would require this C105-238P impeller as it is used for a 1 HP uprated motor.
Is the 238P and the 238PEBA interchangeable.. I have the USQ1202 motor and am wondering if the 238P (from old motor) is sufficient