Part # 5002-10
Manufacturer Code 355389
Alternate Part #'s 355389, PAC1013141
Impeller Locking Screw - 355389
Fastener Size | 1/4" |
Thread Pitch | 20 |
Fastener Length | 1-3/16" |
Head Type | Hex Washer - Slot |
Material | Stainless Steel |
I can’t get this screw out, any advice?
Hi Mary, sometimes using a small amount of muriatic acid will clean corrosion that could be causing the skew to stick. Also, WD40 or heat may also assist to break the screw loose.
Reply
is this locking screw 5/16 thich. how many threads to the inch. Does it hold the impellar in place.
Reply
Hi, John, This Impeller Screw Fastener Size is 1/4" and the Thread Pitch is 20. It does keep the impeller secured to the motor shaft.
Reply
I was replacing my motor on my Pentair superflo. The bolt for the impeller is bent. it is a left handed thred does it have to be in the pump?
Reply
Hi, Curt. The impeller screw is left-hand threaded.
Reply
Is this a left hand threaded bolt? The old one broke upon replacement of motor. Do i need to replace it?
Reply
Hi Chis, This Impeller screw is left-handed thread. You do not need it but if you want to you can replace it.
Reply
The Most Recent Reviews
(5 out of 5 stars) It works good.
Reviewed By: ()
It works good.
Was this review helpful to you?
(5 out of 5 stars)
Reviewed By: ()
the right screw for the impeller, reverse thread, no difficulty attaching and tightening it down.
Was this review helpful to you?
(5 out of 5 stars) Right Part
Reviewed By: John P. from Malta, New York ()
Pros: Just what I needed
Cons: none
Have old pump and this part was the right one to complete my pump re-build. As always INYOPOOL comes thru and received part quickly. Thank You INYOPOOLS that is why I keep coming back. Also all your tips and how to accomplished task on your pool as a home owner are fantastic keep them coming.
Was this review helpful to you?
(1 out of 5 stars) Impeller bolt
Reviewed By: Rob B. from Lansing, MI ()
The bolt bent as I was installing it.
Was this review helpful to you?