Part # 5271-73
Manufacturer Code 18313301
Dimensions 5" L x 5.5" W x 2" D
Alternate Part #'s 18313301, 356546
MAGNETEK / A.O. SMITH 1-83333-01 THIS IS A TWO-SPEED TOGGLE SWITCH KIT USED ON THE MAGNETEK LASER SERIES THRU BOLT MOTORS THIS IS A PLASTIC END COVER WITH A TOGGLE SWITCH MOUNTED IN IT. TOGGLE SWITCH HAS 2 WIRES WITH FLAG CONNECTORS AND 1 WIRE WITH A WIRE NUT ATTACHED TO IT. TOGGLE SWITCH POSITIONS ARE HI, LOW, AND CENTER OFF EXACTLY THE SAME ITEM AS 5004-23, BUT THAT ONE COMES FROM PENTAIR
Single-speed Toggle Switch Assy. - On/Off - 18374501
I have a Hayward as seen in the pictures. Is there a way I can convert my single speed motor to a 2 speed motor or will I need to replace the motor altogether.
Unfortunately, you will not be able to make that single speed motor a two-speed. The only route is to start with a whole new dual speed motor; which would be the BN50V1. The shaft seal to complete the motor installation is 5111-03.
I was looking to replace my SP1500FT Microprocessor Pump Timer but see it is no longer available. The Q&A on that page directed me here. My pump is the Hayward SP1515-Z-1-EFTC. I believe it is single speed only. Will this 2 speed switch still work properly? If not, what is recommended?
How does the 18313301 Switch wire into A O Smith motor B2979
This switch replaces Intermatic air switch #RC 2343?,does it include installation installation instructions?
Thank you, Siegfried Zapp
Does this switch work inplace of Intermatic switch #RC 2343 pt ?
Thank you! Siegfried Zapp,I don't mind the manual switching.
Hi, Siegfried Zapp. This Toggle Switch Assy can be used if you have a compatible motor bypassing the RC2343PT controller.
I just purchased a bn36 motor and need a 2 speed toggle switch only.my switch broke off on my original motor.
Hi, Pete. This 2-SPD Toggle Switch - 18313301 will fit the Century BN36 Motor.
Probably a silly question, but how hard it is to install this separately? I will be ordering a BN50 soon, but the last replacement pump I order through another company already had the switch combined with it.
Will this switch work with a Waterway pump Model PH2150-6p..2 speed..if not where can I get one?.. Thanks
Hi Vincent, This can work with the Waterway PH2150-6P model pump depending on the end cap that you have. This will not work if you have a switchless motor.
Will this switch on a waterway 2.5 horsepower pump. My toggle switch has broken off.
Thanks for all of your help! The products I've purchased from you has always worked GREAT!
Hi Mike, This Switch can work on a certain Waterway pumps. However without know which model you have we're unable to confirm. If you can provide the model number or motor no. we can confirm.
(4 out of 5 stars) Replacement Switch & cover
Reviewed By: Buzzard from Akron, Ohio ()
Pros: Higher quality than the orignal
Cons: Did not "exactly" mounting holes
Although the cover was heavier than the original, the fit was perfect. The switch was much heverier duty as well. The mounting did not line up exactly with new cover on - but 1/2 hour of modifiing the cover hole was all it took. Add was considerably cheaper than the dealer wanted to order it.
(5 out of 5 stars) perfect fit switch
Reviewed By: DONALD W. L. from Lima Ohio ()
Pros: fits perfect
This cover fit perfectly on my Jacuzzi pump and the wiring for switch was exactly like my old cover. Will not have a chance to actually try out the switch until next spring/summer.