Thermal Fuse (005899f)

$36.99

IN STOCK
FREE SHIPPING

Part # 6234-36

By Raypak

  4.34 Average  

Details

Top

Part # 6234-36

Manufacturer Code 005899F

Dimensions 1.75" L x 0.75" W x 1.5" D

Alternate Part #'s 005899F, 650914, RAY1513630

Product Description

Thermal Switch

Top

?     Asked on 7/16/2018 by Rick

Another question my heater has a slow drip and steams when it comes on. What could psooibly leak at 1 1/2 yrs old. It’s hard to see inside I took off top cover and and both small side panels . It’s a raypak 206a dual control gas heater.
 Reply

A  Answered on 7/17/2018 by InyoPools Product Specialist Lennox H.

Hi, Rick. Replacing the Gasket O-ring (set Of 2) - 006713F is the only thing that comes to mind. 
 Reply


?     Asked on 7/16/2018 by Rick

My ray pack pool heater is only 1 1/2 years old roll out switch popped what is the temp max on switch and part number? My model is p-r206a-en-x thanks
 Reply

A  Answered on 7/16/2018 by InyoPools Product Specialist Lennox H.

Hi, Rick. This Thermal Fuse will trip if the temperature exceeds 152C/305F.
 Reply


?     Asked on 9/7/2017 by jim

my thermo fuse burned out cause of flame back on fuse whats the cause burned 2 of them
 Reply

A  Answered on 9/11/2017 by InyoPools Product Specialist Lennox H.

Hi, Jim. An over-temperature condition, caused by an excessive restriction in the heat exchanger flue passage.
 Reply


?     Asked on 7/24/2017 by Glenn

I have a Raypak RP2100 406K btu digital pool heater and need a new roll out switch - can you provide correct part #?
 Reply

A  Answered on 7/25/2017 by InyoPools Product Specialist Lennox H.

Hi, Glenn. This Thermal Fuse - 005899F is also referred to as the Rollout Switch.
 Reply


?     Asked on 6/14/2017 by Judy

I have a 2 year old Raypak pool heater, the model number has 406 in it. We're getting a message on the heater that the rollout switch is open, so we figured out where that is inside the heater. I see a lot of identical fuses online, but there's always some letters or numbers that don't match up, including the one you're selling. Mine says 650914/Microtemp/G4AM0609/TF 152C ABA. This agrees pretty much with yours except for the last 3 letters. Is that important? Thanks.
 Reply

A  Answered on 6/15/2017 by InyoPools Product Specialist Patrick P.

Hi Judy, thanks for the question! No those last digits will not make a difference and this is the part you will require.
 Reply


?     Asked on 6/12/2017 by Ron

my heater states roll out switch open what part is that so I can replace it
 Reply

A  Answered on 6/16/2017 by Product Owner

That is the thermal fuse. When you open the front of the heater it is the small fuse that has 2 wires going into it and held in with 1 screw. I would also take the top off of the heater and clean out the grate my heater had a lot of leaves blocking the vent and that's what was making my fuse blow. Good luck.
 Reply


?     Asked on 10/2/2016 by amit

does this sw work for model P-R266A-EN-C
 Reply

A  Answered on 10/4/2016 by InyoPools Product Specialist Scott W.

Yes, that fuse is for that model of heater.
 Reply


?     Asked on 9/6/2016 by

my displat on my heater says rollout sw open. I looked at the fuse and it is not burnt or popped or broken. what does open mean on this part?
 Reply

A  Answered on 9/21/2016 by InyoPools Product Specialist Stacey M.

Hello Sean, I would contact Raypak 805-278-5300 to run diagnostic/troubleshooting.
 Reply


?     Asked on 6/17/2015 by ron

how can u tell if its no good
 Reply

A  Answered on 6/20/2015 by InyoPools Product Specialist Matt S.

Hello Ron, the fuse linkage between the prongs would be melted or popped.
 Reply


?     Asked on 10/24/2014 by scott

Just wondering what the temp rating is on this part (005899F) thank you
 Reply

A  Answered on 10/24/2014 by InyoPools Product Specialist Brian M.

Hello - I spoke to a technician at Raypak ( 805-275-5300 ) and they said that the temperature rating for item number 005899F is 300 degrees fahrenheit.
 Reply


?     Asked on 9/30/2014 by Guest

Is this part the same as a flame roll out safety switch for a raypak 2100?
 Reply

A  Answered on 9/30/2014 by InyoPools Product Specialist Patrick P.

I spoke to Technical help at Raypak ( 805-278-5300 ) and was told that part number 6234-36 is the correct replacement.
 Reply


Top

Review Summary

 (Average 4.34  out of 5 stars)
3 Rating
5 star:
 
(2)
4 star:
 
(0)
3 star:
 
(1)
2 star:
 
(0)
1 star:
 
(0)