H-Series Transformer (CHXTRF1930)

$74.99

IN STOCK
FREE SHIPPING

Part # 6221-58

By Hayward Pool Products

  5 Average  

Details

Top

Part # 6221-58

Manufacturer Code CHXTRF1930

Dimensions 4" L x 4" W x 2" D

Alternate Part #'s CHXTRF1930, HAY1511424

Product Description

H-Series Transformer

Top

?     Asked on 6/9/2019 by

does this transformer fit hayward H200 pool heater(electronic)
 Reply

A  Answered on 6/10/2019 by InyoPools Product Specialist Patrick P.

Yes, this transformer does fit Hayward H200 pool heater electronic ignition.
 Reply


?     Asked on 5/30/2017 by gabe shtanko

hi,i'have a h 250 fdn hayward heather,it stays on standby,wont go to spa or pool .the fuses look fine,do you think that could be the transformer or the board ?
 Reply

A  Answered on 6/1/2017 by InyoPools Product Specialist Lennox H.

Hi, Gabe. If the unit is giving you an error code, you can use the Universal H-Series Diagnostics Manual to resolve the issue.
 Reply


?     Asked on 3/14/2016 by Phil

Hi, I have a Hayward h250 and I am getting the IF code. I have narrowed it down to the control valve not opening. I took a voltage reading at the control valve and it is jumping around never reaching above 20 volts. In your best opinion Should I start with control panel or transfor?
 Reply

A  Answered on 3/15/2016 by InyoPools Product Specialist Alan M.

Hello Phil and thank you for your question. Per Hayward's instruction manual, if 24VAC is not present, gas valve relay on control module is defective. Replace control module. Feel free to consult Hayward directly at 888-429-9273 to confirm. The Hayward online manual for your H250 Heater can be reached with this link. If there is anything else I can assist with, please e-mail me back. Thank you, Alan.
 Reply


?     Asked on 8/31/2015 by Bob S

I followed the troubleshooting guide and it seems to indicate the transformer . If the transformer is bad would I get any lights on the digital display ? Because I get nothing on the display , no lights and no codes yet I know there is power to the heater .
 Reply

A  Answered on 9/4/2015 by InyoPools Product Specialist Lennox H.

Hi Bob, You can use a volt meter to test the Transformer to make sure that it is receiving 120 or 220 volts and 20-26 volts is leaving. If that's happening then it would be the display board.
 Reply


Top

Review Summary

 (Average 5  out of 5 stars)
1 Ratings
5 star:
 
(1)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)