My pool pump motor indicates V115/230. Will thistimer accommodate the pool pump? Also,can you tell me the voltage on the clock motor?
Reply
Your pump can be wired either 115V or 230V If you have your pool pump wired at 230V than you would want to go with the T104P3 timer if you have the pump wired at 115V than you would want to go with the T101P3 timer. T104P3 timer has a 230V time clock motor and the T101P3 timer has a 115V time clock motor. You may purchase either of these time clocks through the following link http://www.inyopools.com/controls_intermatic.aspx
Reply
I have a T104R timer is this the proper replacement?
Reply
The T104R3 or the T104P3 are direct replacements for any T104 timer. The only difference between these two timers is that the T104R3 comes in a metal enclosure and the T104P3 comes in a plastic enclosure.
Reply
How many on/off devices come with the unit? I am using this for my eletric hot water heater, I want the heater to come on around 5:00AM and off at 7:00AM, then on again at 5:00PM and off and 7:00PM. So I guess I'm asking can I program two on and off's or do I have to buy something else?
Reply
This timer comes with one "On" tripper and one "Off" tripper but can accommodate up to 12 On/Off positions. So to accomplish the following "...come on around 5:00AM and off at 7:00AM, then on again at 5:00PM and off and 7:00PM" You would require the purchase of the timer which comes with 2 trippers, plus the purchase of one additional set of on / off trippers which you may view or purchase here http://www.inyopools.com/Products/02400004003526.htm
Reply
Does this timer have knockouts for the electrical and where are they located?
Reply
Here is all the information we have regarding the knockouts: Knockouts - Combination 1/2" - 3/4" nominal knockouts, one on the back and each side of case, two on bottom
Reply
I have a 1.5 HP pump for circulation and a 1.5 HP booster pump for my pool sweep. Will this control both if I wanted them to come on at the same time?
Reply
Hi, The Intermatic Timer 220 Volt Metal Enclosure can handle the two pumps if the max load does not exceed 40 amps.
Reply
I have just purchased the QC1102 motor to replace my old 1hp motor (K48L2PA105) I have a max e glas II pump (P4E6E-151L). The circuit breaker in the subpanel outside are double pole 15 amp (30 amp total). Is this the correct timer? I can't tell what timer I currently have as all labeling is gone.
Reply
Hi Cory, This is the correct timer that you can use with a double pole timer and the QC1102 motor.
Reply
I have a 1 1/2 HP hayward pump wired for 230 volts and a salt chlorinator which is 120. Can I use 1 timer for both? They pump is on a double pole 15 amp with 14/3 wire and the chlornator is on a sinble 15 amp with 14/2 wire.
Reply
Hi, Bob. Unfortunately, you can not. The chlorine generator will have to also be wired for 230 volts.
Reply
Is the stationary pointer on intermatic timer fixed or screw installed. How does it get damaged and fall off?
Reply
The pointer is fixed. They really do not fall off and if so rarely to never. Maybe severe corrosion or damage to the unit would cause them to come off.
Reply
i have a model T30404R casing with 2 Intermatic timers. One of them no longer works. When I take it out I see the part number of the motor, but, not the part number of Intermatic unit. What Intermatic unit should I order?
Reply
Does the timer come with the "screw switches" for turning it on and off? They are not displayed in the picture!
Reply
Yes, this unit comes with Two Intermatic Trippers 1 Off & 1 On - 156T1978A
Reply
I have a pentair 1.0 HP 230V with a pentair intellichlor running 24/7. Can I put a timer on it. What's the benefits? Will it save me money,and help save my equipment. Will the timer replace my outside breaker.
Hi Mike, you don't need to put a timer on the Intellichlor salt chlorine generator system however this timer is a good model to use with a pool pump that is 220/240 volts.
Reply
I have a t104r3 that I need to replace the mechanism only because the lever to turn it on is worn off. what is the proper number for that replacement?
Reply
Hello Eddie. The Intermatic Timer Mechanism T104M is the correct replacement timer mechanism for the Intermatic Timer model T104R3. Intermatic Timer Mechanism Only 220V - T104M
Reply
