Can I replace the bulb with water above the return? Do I have to drain the water so it is below the return?
Reply
Page 5 of the Aqualuminator owner's manual here http://www.inyopools.com/manuals/365/pentair_lighting_aqualuminator.pdf gives detailed instructions on how to replace an Aqualuminator bulb. Per the owner's manual it states that "It is desirable to reduce the water level to the lower edge of the flow director. This makes bulb assembly replacement easier, but it is not mandatory."
Reply
how do I replace a bulb & gasket on my aqua laminator pool light
Reply
Bob, You can find the relamping instructions on page 5-6 of the Aqua Luminator owner's manual.
Reply
Is there a temperature rating for this bulb? My pool is heated and the water temp coming through the return can be upwards of 95 degrees Fahrenheit. Would this be an issue with the seal on the bulb?
Reply
Hi Rick, I looked through the Pentair Aqualuminator Owner's Manual and did not find any information that states a maximum temperature, just a temperature for freezing conditions. You can call Pentair at 1.800.831.7133 to verify.
Reply
I'm replaceing the bulb, what's the differences between the aqualuminator bulb assy. Pn 69100000 and bulb assy. Pn 61949 AQL 500, insturctions say they are not interchangeable.
Reply
Randy, The connections on the end of the bulb are different. Please be sure to order the correct replacement.
Reply
Is there an Led Version of this Light? I have the Halogen bulb version...the halogen bulbs burn out quickly
Reply
Hi, Richard. Unfortunately, there is not an LED version for this Aqua Luminator bulb.
Reply
