?     Asked on 7/16/2015by bill stevenson

is this slotted not threaded?
 Reply

A  Answered on 7/16/2015 by InyoPools Product Specialist Hector F.

This is a slotted version port sensor kit.
 Reply


?     Asked on 5/11/2016by Russell

What is the difference between the R0452500 sensor and the R0476400? I've seen them on other websites and the photos & part numbers were the opposite of what this site indicates. Are they both compatible with the Aquapure APUREM w/ PLC1400 cell? Knowing the troubled history with the tri-sensors I want to make sure I have the "latest and greatest" when I upgrade my old Aquapure control unit to the APUREM.
 Reply

A  Answered on 5/14/2016 by InyoPools Product Specialist Charlie R.

Russell,If you're replacing the tr-sensor for your APure unit, I would go with part # r0452500, as that is the original sensor that came with your unit. It should say APURE on the sensor itself.
 Reply


?     Asked on 9/9/2016by Inyo Visitor

My flow sensor has died and I need to replace it. The replacement part number is R0452500 but the picture for this replacement part shows show one protruding slit on one side of the sensor and two on the other side of the sensor where it slides into the salt cell. My old sensor and salt cell only have one slit to slide the sensor into the salt cell. Did they change the design? Is there an appropriate replacement part for my salt cell?
 Reply

A  Answered on 9/9/2016 by InyoPools Product Specialist Stacey M.

Hello, the R0452500 is part number 2803-085. If you would like to confirm with Zodiac 800-822-7933 about part and design updates.
 Reply


?     Asked on 5/5/2018by Inyo Visitor

Is there any difference between the Jandy PLC1400 sensors in terms of control box compatibility? One has an indicator light box in the cord . The other has a chip at the connection end to the control box board.
 Reply

A  Answered on 5/6/2018 by InyoPools Product Specialist Lennox H.

Hi. The Sensor with the chip and all previous versions has been superseded by this Port Sensor Kit - R0452500.
 Reply


?     Asked on 7/9/2018by Inyo Visitor

I need to replace the sensor portion only. My model is an AquaPure Model R0452400. The entire salt system was replaced in August of 2015. Could you please advise
 Reply

A  Answered on 7/9/2018 by InyoPools Product Specialist Lennox H.

Hi. This Port Sensor Kit - R0452500 is compatible with your cell and system age. 
 Reply


?     Asked on 7/2/2019by monique desjardins

Hi my part number is r0452100 will this part fit. Thanks
 Reply

A  Answered on 7/17/2019 by InyoPools Product Specialist Hector F.

The part number you have provided BEING r0452100 references the unions part number 2803-075
 Reply


?     Asked on 7/3/2019by William Petersen

How do i know if i need a new flow sensor on aquapure 1400 or if its the circuit board
 Reply

A  Answered on 7/11/2019 by InyoPools Product Specialist Matt S.

Try this Jandy AquaPure Troubleshooting Guide to help you the source of the problem.
 Reply