?     Asked on 7/5/2008by Guest

Can I install my self? What is the refrigerant? Must it be replenished?
 Reply

A  Answered on 7/5/2008 by InyoPools Product Specialist Patrick P.

Yes, anyone can install the pool cooler themselves. In the bottom basis in the box is the installation ,operation manual with diagram and parts list. You can go to a local hardware store and get the proper installation parts. There is no refrigeration, no freon or gas to operate. Electric 110 Volt 60 Hertz 8 Amps fan does the work. This unit hooks up with the pool pump breaker. The home breaker powering the pool pump and pool cooler must be 20 Amps or above.
 Reply


?     Asked on 7/16/2008by Guest

Does the Glacier pool cooler have a thermostat? If not how do you regulate temperature?
 Reply

A  Answered on 7/16/2008 by InyoPools Product Specialist Patrick P.

The GPC does not come with a temperature control.  In most cases an owner will run their cooler at night along with their pool's cycle.  An owner may find that running the pool a longer or shorter amount of time will give them their optimal temperature.
 Reply


?     Asked on 8/12/2008by Guest

Is this an evaporative cooler - or does it just cool water by running at night with lower temperatures? How does it work?
 Reply

A  Answered on 8/12/2008 by InyoPools Product Specialist Patrick P.

Yes, this system is based on evaporative cooling.  The manufacture has modified the technology to accommodate the swimming pool industry.  The pool water is circulated through the system while a fan cools the droplets and removes the heat from the water instantly.  The water is then pumped back into the pool lines and circulated back into the pool.
 Reply


?     Asked on 7/4/2009by Guest

Our summer temperatures average 98-103. Our pool is extremely warm. How much of a drop in water temperature can we expect? Does the unit have to run continually to be effective and finally, what type of operating costs can be attributed to this unit?
 Reply

A  Answered on 7/4/2009 by InyoPools Product Specialist Patrick P.

The pool cooler will drop the pool 10 to 15 degrees. The operating costs are around a dollar a night on running the cooler 10 hours. It does not have to run continually, just run it at night when the sun is off the pool and it will perform and drop this pool down and be refreshing.
 Reply


?     Asked on 7/12/2009by Guest

Can this cooling system be used with a salt water pool?
 Reply

A  Answered on 7/12/2009 by InyoPools Product Specialist Patrick P.

All of the chillers we carry are salt water compatible. After a couple of weeks of usage, spray down the pool cooler with a garden hose to wash off salt residue if any.
 Reply


?     Asked on 4/7/2015by DAVE

What is the overall weight of the GPC210 Glacier Chiller Unit ???
 Reply

A  Answered on 4/7/2015 by InyoPools Product Specialist Andy O.

Dave, the dry weight of this unit will be 150 pounds.
 Reply


?     Asked on 7/30/2015by Char

What is the footprint or ground space needed to accommodate this unit?
 Reply

A  Answered on 7/31/2015 by InyoPools Product Specialist Joe S.

Unit  Dimensions are 54" Diameter 41.75". 1. Appropriate site location and clearances. Cooler must be installed at least 18 inches away from buildings, walls, or fences made from material that could degrade from water exposure. Our coolers are open systems that may experience some water splatter or misting. 2. Sufficient supply clean air and ventilation around and above the unit. A minimum of a 5 foot clearance above the unit is necessary to avoid condensation on the structure above. 3. Adequate water flow is required by your existing pool pump. 4. Do not locate pool cooler in an enclosed room (i.e. maintenance room, garage, utility room, equipment room)
 Reply


?     Asked on 7/30/2015by Char

Our pool (not including the hot tub/spa) is 30k gallons. The material is a light colored (French Gray) pebble sheen. On your website it mentioned that if you have ANY color pebble, you should upgrade to next size pump or expect it not to cool as fast or as much. My question is, should we go with 30k cooler or upsize? And what about it being pebble sheen effects ability to bring temp down? What can we expect for temp drop? Thx.
 Reply

A  Answered on 8/4/2015 by InyoPools Product Specialist Lennox H.

Hi Char, You will need to up size to the Glacier Pool Chiller up to 45,000 Gal (GPC215). On average with using the units at night you can see a 10-15° temperature drop.
 Reply


?     Asked on 8/21/2015by Bill roe

i have one of you chillers but for some reason can t get a service manual to repair my cooler. Example how to you replace the sump pump. Is it necessary to un bolt the outer casing. I can not lo Locate a dealer or service In Florida
 Reply

A  Answered on 8/25/2015 by InyoPools Product Specialist Brian M.

I did find some retail and service contacts in Florida : PERFECT TEMPWEST PALM BEACHTO FT. LAUDERDALE 561-737-1800 . BACKYARD OUTLET FLORIDA PANHANDLE 850-315-0055. FLORIDA PLAY STRUCTURES AND WATER FEATURES INC.CENTRAL AND SOUTH EAST FLORIDA 813-704-4395. CES COMMERCIAL ONLY 800-940-1557 x105SPIES POOLS, LLCCOMMERCIAL ONLY ORLANDO AND CENTRAL FLORIDA 407-847-2771 .  Please click here for the Glacier Pool Coolers Manual
 Reply


?     Asked on 9/9/2015by Inyo Visitor

does GLACIER make a cover for its chillers ? i have a GCP-210
 Reply

A  Answered on 9/14/2015 by InyoPools Product Specialist Lennox H.

Hi, Glacier does not make covers for their units.
 Reply


?     Asked on 8/12/2016by erick

65,000 commercial pool want to purches glacier pool cooler 80gpm/120,000 gallons gdc-230 in palm springsw will this help any
 Reply

A  Answered on 8/12/2016 by InyoPools Product Specialist Stacey M.

Hello Erick, unfortunately we don't carry Glacier products anymore.
 Reply