Part # 58-155-4000
Manufacturer Code PE653RC
The “Multi-Wave” Wireless Control System Controls Pools/Spas and now your Home! Combine the PE653 Multi-Wave Controller with the PE953 Multi-Wave Hand Held Transceiver and automate your pool/spa and even your home with the most technologically advanced wireless control system in the market today!
The Multi-Wave is designed as a “plug and play” system. Install the water sensor PA122 (see page 21) and watch the Multi-Wave thermostat come alive to maintain your pool and/or spa water temperatures. Install the air sensor 178PA28A (see page 21) and let the Multi-Wave freeze protection system take over to protect your investment. Connect your equipment to the intelligent RS485 communication port and relax as the Multi-Wave recognizes and controls your equipment with ease.
Enclosure & Control: NEMA 3R rated for Indoor/Outdoor installation in beige finish 93 /8 in. (23.8 cm) H x 51 /2 in. (14.0 cm) W x 35 /8 in. (9.2 cm) D
Enclosure Knockouts: Combination 1 /2 – 3 /4 in. nominal knockouts, one on back and each side of enclosure and two on bottom
Shipping Weight: 5.4 lbs (2.3 kg)
Agency Approval: CSA/C-US
Control Supply: 120, 240 VAC, 50/60Hz, 5-Watts Maximum
Circuit #1: 20 Amp Resistive (17 FLA, 80 LRA), 120, 240 VAC 50/60 Hz Circuit #2 thru #5: 15 Amp Resistive (10 FLA, 60 LRA), 120, 240 VAC, 50/60 Hz
Does this come with the air temp sensor included? Not sure since it listed it as an 'accessory item'.
Yes it does, if part number 58-155-4000 is ordered. Included: Owner’s Manual Equipment Labels Three AA Batteries Hand Held PE953 Transmitter Small Flat Head Screwdriver Water Sensor with Hose Clamp Receiving PE653 Controller with 2T2485GA Enclosure Air Temperature Sensor Water Temperature Sensor
I already have a Z-wave system and only need to control 2 items. A single speed (240V) Pentair pool pump and a standard (120v) light switch for my LED pool light. So if I am not concerned about pool temperature, freezing, and valve control, can I just purchase the PE653 without the remote and other items, and still accomplish what I am looking for? Will I be able to program the pool pump remotely?
Hi, Jim. Yes, you can use just the PE653 Receiver, sync it with the Z-Wave Controller to control the pump and light.