Model # 94028917
Model # 94028917
Patented air-cooled heat sink allows pump to run dry without damage to shaft seal. UNCONDITIONAL TWO-YEAR WARRANTY AGAINST SEAL FAILURE.
Diffuser/casefit plus "pry" tabs allow for simple assembly or disassembly
Ring-Lok™ strainerallows "tool free" access to the strainer basket.
Internal ribsin large strainer basket assure flow even when filled with leaves and debris.
High efficiency impeller/diffuserfor increased performance and priming capability.
Self priminghydraulic design provides suction lift up to 10' (3 m) above water level.
Floating eyeseal between the closed impeller and diffuser maximizes pump efficiency for best flow and pressure.
56 Frame mount square-flange dual-voltage motorsare standard on all units.
2" (51 mm) FNPT plumbing connections.
One piece casemolded from glass-reinforced,corrosion-resistant thermoplastic with two convenient drain plugs for winterizing.
Maximum water temperature 104 °F (40 °C).
Click here for more Jacuzzi Pumps
Would this pump system be the right replacement for my Swim Jet pump? the swim jets operate separately from the pool filter system pump. The old pump was a 2hp Century Centurion, 60hz, 3450rpm, 230 volt. I note this pump says 3/4 to 2hp. can it be set to 2hp single speed? Thanks, John
Hi, John. It is possible that this pump will be able to operate a Swim Jet System. However, to confirm you will need to provide us with wither the model of your current pump or the total specification of the swim jet system. Specifications like the total length of pipe, plumbing size, and the flow rate of the swim jets.
Is this for a pool in ground 10,000 gals
Hi Ramon, The Jacuzzi Cygnet 2 HP Pump may be too big for a 10,000 gallon pool. I would recommend watching our How To: Size a Pool Pump guide for make sure you get the correct size pump.
Is this U.S. Made?
Hello Ramon. The pump is made in Canada. For a little information on the manufacturer you can follow this link.
What is the pump case (ENCLOSURE) design operating temperature? The question is for approx.300 gallon spa tub pump.
Hi Earle, I don't have the exact pump housing operating temperature but it can handle much higher temperatures then what a standard spa operates at (104 F). The motor operates up to 140 F.
Is the motor for this pump a 2 speed? Is the filter basket removable?
John,This is a single speed pump (3450 rpm's). The strainer basket is removeable so that it can be emptied out. You can view dimensions here.
IS THIS PUMP USED FOR IN GROUND POOLS?
This pump is intended for in-ground applications. It should be hard plumbed into the circulatory system of the pool.