Part # 4717
Jandy NeverLube Valves are designed for durability and backed by a lifetime guarantee. Rigorous quality control checks are used to ensure these valves will not leak, break, melt, lose pressure or slip.
Click here for more Jandy Valves
can you install Union connectors to the Jandy Valves for quick repairs or replacement if needed? I am in the process of replacing my pump and re-routing some new pvc Piping and considering replacing the Valves as well. What would you recommend?
can the valve be rotated to block the inlet? if not, which valve should I buy
Hi, Dan. This valve can be positioned to block the inlet.
is there a way to remove broken pvc from vale inlet and outlets.
Hi, Unfortunately, there is not a way to remove broken pvc from a valve port.
what is the part number for a replacement diverter and O-rings for this valve? Mine is leaking and the diverter has separated.
Jeff, Thank you for your question. I can help you with that. This link I am providing is the link for the rebuild your valve . Here are all the spare part for you to rebuild your valve. Thank you for choosing INYO for all your pools needs.Click Here to rebuild your valve: http://www.inyopools.com/pool_parts_jandy_standard_never_lube_valve_parts.aspx
I have this valve installed at my pump. I have a lot of air coming out of the pool jets and it doesn't stop. If I rotate the valve to vacuum and back to skimmer, it clears the air immediately. Do you have any suggestions?
I would recommend checking the gaskets/o-rings on the valve and pump housing. They may be letting air into the system.
Will the Jandy 3way Neverlube valve allow me to close off two ports at the same time?
No, the Jandy 4717 3-way valve will only allow you to have one port blocked off at any given time.
Why do the Jandy valves list ID and OD for each valve?
Each Jandy valve is designed to connect to two different size pipes. For example on a valve shown with ID 1 1/2" and OD 2", a 1 1/2" pipe can be glued inside the port or a 2" pipe can be glued on the outside of the port.
I just bought a house with a pool. i'v never had a pool so my question is when the pump comes on automaticaly (it has a timer)what position is the jandy valve supposed to be turned to the main drain or skimmer?
You can turn the valve so that all the suction is going to the drain at the bottom of the pool, this will suck any dirt or debris on the bottom of the pool through the drain and clean through the filter. If you turn the valve so the suction is going to the skimmer then you will be pulling any leaves or debris off the surface of the pool. You can also set the valve in a half way position so you are pulling from both the skimmer and main drain. I hope this helps.
Question on the 2" jandy 3 way valve. What are the connections. Are they all female socket 2", or are any outlets reduced in size or a male connection. Please advise. Thanks
For the 4717 you can attach it to your plumbing two different ways. You can take 2" piping and have it fit inside the valve (so the valve would be female) or you can take a 2 1/2" pipe and fit it over the valve (so the valve would be male).