END COVER SWITCH ASSEMBLY (615332)

Metal end cover with toggle switch for 2-speed motors. Toggle switch provides Lo, Off, and High functions.

Directions for connecting 615332 to AO Smith STS dual speed motors:

All references to terminals of the terminal board are in quotes

1. Remove and store black lead from the low speed terminal of toggle switch assembly. (this black lead may be scrapped or stored for later use if changing back to original setup).

2. Remove black lead from "A" and connect to low speed terminal of toggle switch assembly.

3. Remove yellow lead from "L1" and connect to "A" (where black lead was removed in step 2).

4. Connect yellow lead from hi speed terminal of toggle switch assembly to "A” on top of terminal board.

5. Connect purple lead from common terminal of toggle switch to "L1".

6. Before replacing motor canopy, be sure all leads are properly placed to prevent damage from governor and/or canopy.

7. Connect power to L1 and L2.Toggle switch will now control whether either high or low speed are used.

Click here for STS1072R Dual Speed Motor wiring diagram

Click here for STS1152R Dual Speed Motor wiring diagram

Ask us a question regarding 5271-79