By Jacuzzi Inc.
Model # 3560-4
Manufacturer Code 941351200015
Alternate Part #'s 500FMH-15, 500FMH15, 941351200015, 56-105-1005
JACUZZI FULL MOON POOL LIGHT
FEATURES:
• Patented Lenslok snap ring allows easy access to bulb
• Polished stainless steel face plate
• Retrofitable to most existing niches
• Exact replacement for existing Amerlite Pool Lights
• 100% Tested for safety and quality assurance
• UL listed
DIMENSIONS:
•FACE RING DIAMETER: 10-3/8”
•FRONT TO BACK: (SHELL ONLY) 6-5/8”
•FRONT TO BACK: (TO LENS FRONT) 7-3/4”
•SHELL REAR DIAMETER: 2-5/8”
Good day,
I am looking for a in ground pool light replacement on the wall. The existing 1 was made by Jacuzzi Canada the dimension are 7.25" diameter (measured in front glass). The back side is smaller and the circumference is 16", the deep the 7".
Would like to know if you have any light fit into this specs? Thanks.
Best regards
Calvin Chu
Reply
Hi Calvin, Could you send us some photos of your light, that would help out quite a bit.
Reply
Same question as the above poster. Picture here:
https://www.troublefreepool.com/threads/130905-Please-Help!-Jacuzzi-Light-Problem
Thanks
Reply
I was not able to pull up the picture on trouble free. Is the light fixture you currently have damaged and you are needing to replace it or are you just needing to replace the gasket and the light with a LED light?
Reply
I have an old Jacuzzi light full moon and would like to replace to a newer style if possible.
Old dimension are 8 inch deep from back to front face plate.
Then 8 inches top to bottom.
Reply
Hi, Kevin. The current Jacuzzi Full Moon lights dimensions are 10-3/8" Diameter x 7-3/4" Deep which should match even the older light fixtures. Double check your measurements and or the model of the niche.
Reply
