Part # 4610-38
Manufacturer Code P24218
Dimensions 19-1/4" ID, 1/2"
Alternate Part #'s 071439, 39010200, 71439, o-333, O333, P24218, PUR0514907
Filter tank body o-ring for the following filters:
O-ring serves as a seal between the top and bottom halves of the filter tank.
I have a Pentair 420 Model 178557 Rev E which I need to replace the 0-ring which has enlarged over time and hard to reassemble after cleaning filters. Please confirm the correct part # so I can order it from you. Thank, Dale D
Hello - if you have the Pentair Clean & Clear Plus Cartridge Filter, this is the correct replacement tank body o-ring. Unfortunately, I cannot verify that model number (178557) in our database or Pentair's catalog. Can you confirm on your end that the amount listed above is correct?
Will this item fit the pentair 4000 series?
Yes this is For Use With SMBW CF/4000 Series, Clean & Clear and FNS Plus Filters
Yes, this is the generic oring for the 4000 series
yes it is correct for the 4000 series
I Bought P24218 for Titan RPM. Its 1/2 inch , too thick. Is there another size lid Oring that may fit the titan?
Titan RPM Vertical
Model # 56623200.
60 Sq ft
Hi, Larry1. There is not another size o-ring that will work with the Titan RPM Vertical Grid D.E. Filter. This is the only size that will fit.
Can you please direct me to the Main "O-Ring" for PN DE4820? Manufacture is Hayward.
I need the Part Number to "Main O-Ring" PN______________________________?
I Also need the COMPLETE ASSEMBLED Part Number for filter 3620DE, The one "already to go" out of box and put inside the Filter Tank.This is where I would be be needing the main o-ring seal once I close tank and tighten with "Clamp Screw-On"
I will send photos if require. I think my desdription should be sufficient.
Is this the correct o-ring for a purex triton fns plus de filter? I found the bag of the one we're currently using and it says American o-497-9. When I compare the two, they are different diameters and thickness. Which one is the correct one? Thanks!
Hi, Teresa. This is the correct Tank O-ring - 071439 for the Triton FNS Plus DE filter. The o-ring p/n O-497-9 will not work.
Looking for an o ring, gauge - part number 15-4661. This is for a PAC -Fab Nautilus DE filter Model # NSS-48. This is from an older model service manual.
I have a purex triton fnsp 36 every time I type this in it goes to Pentair are these the same looking for big o ring for lid and few other parts but having trouble looking up is the 4610-38 the right one. thanks
The 4610-38 would be the correct o-ring.
Is this O ring the correct part for my Nautilis NS-24 filter. They don't give a lot of dimensions except 1/2 inch thick. I need a 56 in circumference and 18 inch diameter.
is this the o ring that connects the 2 tank sections together via a SS ring on outside?
Please give part # for this. (quad 60 model) email@example.com
Will this O ring fit American Titan vertical grid filter Presure DE model number 582090 filter area 36 square feet?
Less than 1 hr
The hardest part of tjis process was getting the right size , other sites said theirs would fit. Lucky, Inyo pools has a chat service which give immediate confirmation on fit based on the model number of your unit. Old one off , new one on. Presto!