Part # 4727-1
Manufacturer Code 190059
Dimensions 2.5" L x 2.5" W x 2.25" D
Alternate Part #'s 190059
Pressure Gauge w/ Indicator Rear Mount, OEM - 190059
My valve doesnt have a pressure gauag, but I would like to install one. Is this where it would go?
Hi Autumn, Yes this pressure gauge on this page is the proper pressure gauge for your valve and yes the location in the photo is where the pressure gauge goes.
I am getting conflicting information on the size of the screw fitting size. Your picture implies a 1/2 inch NPT, but those on other sites describe it as a 1/4 "NPT. What is the proper size?
Hi, Timothy. This pressure gauge has a 1/4" MPT threaded end.
The face of the pressure gauge on my S8M150 filter has become so cloudy that it is difficult to read. The rest of the air release valve appears to be just fine. Can I just unscrew the old gauge and screw this one into its place?
Is this the correct replacement part for the CFM-240 Cartridge filter? Do I need to order the tee and relief valve as well? Also, do you have the CFM-240 replacement cartridges, part No. PO5421?
can a side mount pressure gauge be used (190058 number perhaps?) instead of the 190059 back mount (on my TM-22 multiport valve)? If yes, is there a reason or advantage to using the rear mount?
Good morning Tom, You can but I would recommend using what came stock with your system. I don't see any advantages to switching.
is this a replacement for part # 155050 ?
I'm new at this. I am changing the Sand in a Pentair filter. It calls for 45-55. When I removed the old sand, there was small gravel in the bottom of the filter. My question is this, "does the small gravel come in the sack with the sand? Or, do I have to purchase gravel separate?" Dumb I know, but that's my question. Thanks.
Hi, The gravel is sold separately, it not included with the sand.
NEED PRESSURE GUAGE AND VALVE FOR PENTAIR SIDE MOUNT SAND FILTER
I THINK ITS A TRITEN II
Is this the correct pressure gauge replacement for the PacFab model TA 100D. Ours sent out and the book provided with the filter shows the pressure gauge as part # 15-5050.
Hi Sandy, This Pressure Gauge can be used with the PacFab Model TA 100D filter valve.
Less than 1 hr
Wrench Set, Adjustable Wrench
(4 out of 5 stars) great Pressure Gauge
Reviewed By: Nathan H. from Carthage, MO ()
Pros: ease of install
Cons: no directions for recommended use
Very easy to install - simple thread system with an O-ring. Directions on use & recommendations for outer bezel positions would have been appreciated.