is this the correct fan motor for Aerotemp by Aquacal model #AT12000A-A, serial #1009026-F02?
Reply
Hi James, The 1/3 HP 825 RPM 208/230 Fan Motor (ECS3114) would be the correct fan motor for the AquaCal AreoTemp AT12000A-A Heat Pump.
Reply
Which fan motor do I need. Model # ATS15000A_A Serial # 1023275-E03
Reply
Unfortunately, I do not have any information for that, but for that size of heat pump I would think it would need a fan motor that puts out about 1100 RPM. I would recommend giving AquaCal a call at 727-823-5642 to confirm the correct fan motor for that model.
Reply
My fan motor will not rum. It just hums. I suspect the capacitor has failed. Can these be bought as a spare part?
Reply
That replacement capacitor is most likely part number ECS60500, but I recommend giving AquaCal a call to confirm that is the correct capacitor for that fan motor.
Reply
Hi I have a T100 pool heater 3 phase. I fan hums and is free but will not start, struggling to start. All phases are available. Would this be the Capacitor?
Reply
That does sounds like the capacitor. I recommend giving AquaCal a call so they can provide the correct replacement capacitor for your fan motor.
Reply
looking for a fan motor for an Aqua Heat LS
mod MBP-00A
serial YA2292
Hope you can help me
thankyou
Reply
Good Morning Mr. Carpenter, Hope you are doing well. Unfortunately, we did not build the Aqua Heat units and we have no access to their parts or the rating to their parts. If you can provide me info from the motor such as the RPM, blade rotation & HorsePower, I may be able to find a substitute. Thanks Robert Brown AquaCal Tech Support
Reply
AQUA CAL HEAT WAVE - SQ110 - 110AHDEBTJ (MODEL #) FAN MOTOR SEEMS THE FAN MOTOR HAS STOPPED
THEY JUST REPLACED THE CAPACITOR AND CONTROL PANEL ON THE UNIT
DO YOU HAVE A MOTOR THAT WILL FIT - THANKS!
The replacement fan motor for this unit is part number ECS0095. This fan motor needs a new 10 microfarad fan cap, part number ECS6052
Reply
The fan on the pool heater will not run , if you give the fan a spin before turning on the unit it will pickup and run for 20 min making heat. Then fan stops and the compressor continues to run than compressor stops. I replaced the start up capacitor no change.
The unit is Aqua cal Torpical T115B-A 1/4 HP fan
ser no 1004202-102
New Fan ?
Reply
Good Morning Mr. Sterling, Hope you are doing well. This sounds like the motor is heating up & tripping the internal overload. The fan will need to be replaced, but the correct part number is the ECS3115 - MOTOR,FAN 1/4HP 1075RPM C W. INYO Pools can help with that part. Thanks, Robert Brown AquaCal Tech Support
Reply
it looks like this is my solution as well, however is .4 hp equal to 1/3 horsepower?
Reply
Hi Mr. Cunetta, Hope you are doing well. The 0.4 HP is more powerful than the 1/3 & slightly less than 1/2 HP. Thanks, Robert Brown AquaCal Tech Support
Reply
Can you confirm that this is the correct replacement for the model 110AHDEBNA?
Currently when I turn on the pump and give the fan a little nudge, it will spin and the water is heated for about an hour until it eventually stops. After which I get the FS error since the fan isn't moving. Attached the best photo I could take.
Good Morning Joe, Hope you are doing well. The ECS3114 is the correct fan motor for the H110 unit you have at site With the fan running it heats up & then stops when an internal thermal overload trips out. You will need to replace it to fix this issue. Thanks Robert Brown AquaCal Technical Support
Reply
is the ECS3114 the right part for Model 166ARDSBMN ?
the motor just humms.
Good Morning Mr. Vazquez, Hope you are doing well. The proper part number for the SQ166 fan motor is the ECS0095. You will also need the ECS6052 fan capacitor. INYO can supply you with further details. Thanks, Robert Brown AquaCal Tech Support
Reply
Looking for a replacement condenser fan motor for an Aqua Cal 120ARDE, will this fit my unit?
Reply
Good Morning Matt, Hope you are doing well. This motor should be fine for that older Heatwave model but I cannot be 100% sure without the full model number. Please feel free to call us at 727-823-5642 with any questions. Thanks, Robert Brown AquaCal Tech Support
Reply
Is this the correct fan motor for a 120AHDEBNB? I also need a capacitor. Thanks!
Reply
