For a color-changing LED light, how do I switch between the different settings with just a standard light switch?
Reply
The LED lights are designed to move to the next programmed setting each time you turn the switch on and off. This will toggle through the different color settings and shows.
Reply
Hi,
I turned on my light after opening the pool and the light does not work. The only thing that is working are the small LED lights. At night it is hard to see the lights, however, the main white light is not working. Do I need to replace the entire light or do you think its a electrical issue where not enough electricity is getting to the light?
Thanks,
Dario
Reply
Hi Dario, First check to see if you are getting power to the light. Using a multimeter or voltmeter, check the power connection coming out of the breaker box to the light cable. You should have a junction box somewhere near the house. Be careful since the power will have to be on to test it. Next, if you have a transformer to convert the 120V to 12V, check the output of the transformer to make sure you are getting 12V. If you have a switch to turn the light on, check the output of that switch to make sure the switch is good. If that all works, you will have to pull the light at the pool and take it apart to get at the light power connection. Measure the voltage at the back of the light (with the power on) to see if you have power there. If you do have power, then the bulb is bad and has to replaced.
Reply
I have a Jandy RS system. Last night when I turned the pool light on, it cycled through a few colors and went dark. I checked the GFCI and it is good.
Do you recommend I replace the whole light fixture or the Light Engine PCB?
Reply
Hi Sep, You can replace just the Light Engine (R0474100) or the complete light fixture.
Reply
I have an old Pentair 600015/16/17/18 light that has run its course and I need to replace. Will the Jandy Watercolors LED 120V 50ft cord fit this niche. Depth should be fine I am more worried about the width/height. Also, I assume it is compatible with the Jandy iAquaLink 2.0 system? Thanks.
Reply
Hi Chris, Yes this Jandy WaterColors will fit into the niche that your Pentair light was using. The Watercolors is the best option for the iAqualink as the color shows of the light will readout onto your iAqualink.
Reply
Hi, i currently have a Jandy Watercolors light that periodically flashes different colors and won't generate cobalt blue which is the color it is set for. Does that sound like the light is bad?
Also, what is the warranty on the Jandy Watercolors light?
Thanks, Chris
Reply
Hi Chris, It sounds like the Light Engine is bad not allowing that color to be illuminated. These units come with a (1) Year Warranty.
Reply
I have a Jandy CPHVLEDS50 and would like to change the entire light to another LED Light that can easily replace/change the bulb. Is there such a light fixture that can replace this light?
Reply
Yes the PureLine Pure Colors will fit in the same niche as the Jandy and LED Bulb is replaceable with an easy bulb swap. Here you may view the PureLine Pure Colors Light Fixtures based on your part # you will require the 120V version.
Reply
You will have to replace the complete light and cord. The light 2ill not work with your existing aqua controller from that I can tell so keep that in mind as well.
Reply
Do you know if PureLine Pure Colors will work with a Jandy system to control the colors? Thx, Omar
Reply
