Can you use this product to stop a leak in a vinyl liner pool?
Reply
This product will stop a pin hole leak in a vinyl liner pool if the leak is at the floor of the pool. The chemical is heavier than water so it will sink to the bottom.
Reply
How do I use Fix a Leak?
Reply
Depending on the type of leak you are looking to repair, there are certain steps you must take before and after using the product. If you are using Fix-A-Leak to seal a pinhole leak in a pool liner you will want to set your filter vale to recirculate. If you don't have a filter valve on your filter then you can remove the filter element from the filter. Once this has been done you can slowly pour the product through the skimmer. The product has very simple instructions on the container. If you want to see Fix-A-Leak in action, feel free to check out this > >video.
Reply
How long after putting the Fix A Leak in my above ground pool can we swim?
Reply
After the product is used, it should be allowed to cure for 24-48 hours depending on the leak. It would be best to go swimming before the Fix-A-Leak is used. If that's not possible, I would recommend waiting 12 hours before resuming swimming.
Reply
My fiberglass in-ground spa is leaking. I am pretty sure the leak is in the return drain as that is where the leak stops. Do you simply pour the solution in the spa and allow it to find the leak?
Reply
Hi Hillery, You may view The Fix a Leak Spa Instructions here (bottom of page)
Reply
Using Fix A Leak on a Spa Connected to a Pool....Leak seems to be in Spa...
Will an 8 oz be enough??
Reply
Vince, Tha Marlig Fix A Leak 8 Oz will be enough for a Spa that is about 500 gallons of water.
Reply
We have a small pinhole leak in the front housing of our inground pool pump. Would this product stop the leak? Liking this to a pinhole in a radiator.
Reply
John, This product is designed to seal pin holes in plumbing and liners. This would not seal the pin hole in your pump housing.
Reply
our hot tub holds about 500 gals I think it has been empty for about two months what do we need to do before adding fix a leak
Reply
Hi, Bob. You will just need to fill the tub, then remove the filter.
Reply