By Oasis Waterfalls
Part # OAAF-48EL6
Alternate Part #'s 25577-460-600, CMP25577-460-600, 5577-460-600, OAAF-48EL-6
The Oasis Arch Fall creates an elegant arc of falling water. This waterfall has a width of 48 inches and a lip size of 6 inches. All Arch Falls are backfeed; bottom feed is available upon request. The 48-inch waterfall requires a pump that can provide 40 gallons per minute (GPM); pump is sold separately.
To learn more about waterfalls and installation, please see our Waterfall Guide.
The Arch pool waterfall comes in a choice of 5 different sizes, with 4 lip sizes. Below is a chart of the different sizes available for the Pool Waterfall and also shows the dimensions of the actual waterfall.
For more information about installing PVC Pool Waterfalls click here.
For more Pool Waterfalls click here.
Good Afternoon,
Can I use this on my above ground pool?
Reply
Hi Alison, The 48" Oasis Arch Fall Waterfall with 6" lip can be used on an above ground pool, however you will have to build the structure to put the waterfall into, and set it up so that it is tied into the pool circulation using a separate pump just for the fountain.
Reply
Great, but why a separate pump, it cannot be plumbed into the same pump with a splitter and an "on-off" valve? I have done this before with a fountain on my above ground pool.
Reply
Hi Allison, You don't have to use a separate pump for the 48" Oasis Arch Fall Waterfall with 6" lip if you have the ability to tie it into so that it use your existing pump and provide the proper amount of flow needed to operate the waterfall.
Reply
What pump, flow rate is required for this unit?
Reply
Hi, The 48" Oasis Arch Fall Waterfall with 6" lip requires a pump that can provide 40 GPM flow rate. The Hayward TriStar 75GPM Waterfall Pump, Energy Efficient would work but you will need to install a Ball or Diverter valve to reduce the water flow if the flow is too much.
Reply