Model # GLC2PA
Will the GL235 replace an Independent Energy C-35?
Hi. Yes, this Goldline Controls GL235 Solar Controller will replace the Independent Energy C-35 controller.
Maybe a stupid question, but what are the 4 tiny clear/orange plastic pieces for in the kit? Are they wire connectors? I just don't want to be hooking it up wrong and/or cause it not to work properly. Thank you!
Angel, The 4 orange plastic pieces are the LED indicators. They get installed inside of the control box.
my solar valve rotates and wont stop when I put it into Auto or on
Hi. The actuator may be wired incorrectly (check the schematic accompanying the actuator) or the toggle switch is in the incorrect position. The valve should be in the Auto position for normal operation.
I have Aqua solar gl-235 solar heat for my pool. My controller indicates that my sensor is not responding (a red indicater light is on). What problem solutions do you reccommend. Do I need to replace the sensor? If so what do you reccommend and what is the price? This seems like a job that I can do?
Hi, I would first follow the troubleshooting suggestions on page 6 of the Goldline Controls GL235 Manual and proceed with the suggested resolution.
Can the 2" I.D. 3-way valve be configured such that inlet is from one end and outlets are the opposite end + the side end? This would make it much easier to cut into my existing piping system.
Hi, Fred. You can use the three-way valve in the way that you've described.
Can the motorized diverter valve be operated while the pump is running?
Hi, Fred. The actuator can not be engaged while the pump is running.
My sensor light is on, steady red, where do I find a replacement and how much are they?
Hello Mark, I would run diagnostic with Hayward 800-657-2287 to see if there is a specific part that needs to be replaced or the unit itself. The whole unit is Goldline Controls GL235 Solar Controller w/ Actuator, Valve & Temp Sensors - GLC2PA is $369.99
The solar panels will not shift the heating light does not come on there are no sensor lights blinking the temperature gauge is set I tried raising and lowering no results and yes the sun is out thank you
Hi, Troubleshooting instructions can be found on page 5 of the Solar Pool Controller Manual.
So the warm side sensor, does it need to be placed on the roof near the panels?
Hi Phillip, The Solar Sensor is to be pace near the panels so that it is exposed to the same sunlight as the panels.
what is the pipe size of valve
Hi, The Goldline Controls GL235 model # GLC2PA comes with a 2" inside, 2½" outside 3-way Positive Seal Valve.
Can this run on 240 VAC?
The input power can be either 115 or 240 VAC.
How does the temperature sensor for this control mount into my plumbing?
You would drill a small hole in your pipe and then insert the temperature sensor into the hole.