Part # PL0119
Dimensions End Cap = Round, Length = 20", Outside Diameter = 7", Inside Diameter = 3"
Alternate Part #'s 18005, 303953, 817-0081, C-7470, C7470, FC-1976, FC-6465, FC1976, NFC1976, PCC80, PCC80-PAK4, R173573, R178580, XLS-720
NEED TO REPLACE MORE THAN 1 ELEMENT?
PureLine Aftermarket Replacement Cartridge for Pentair Clean & Clear Plus CCP320Filters
Is your pool water starting to look a little dull? Is your pressure gauge reading a higher PSI than normal? Are your pool jets a little less powerful? These are all signs that it is time to replace your pool filter cartridge. Replace your pool filter cartridge today and regain that crystal clear pool water and extend the life of your pool pump.
Typically for single cartridge pool filters we suggest replacing your cartridge every 6-12 months and for filters which take multiple cartridges, we suggest replacing your cartridges every 3 years.
This Cartridge is Commonly Used In
PureLine Cartridge Benefits
Not Your Cartridge?
Is this not your Cartridge? Don't worry we carry thousands of Pool Filter Replacement Cartridges to replace all of the most popular OEM brands such as Sta-Rite, Pentair / Pac Fab, Hayward, Purex, American Products, Jacuzzi, Hot Springs, Coleman, and more. Click here for more Pool Filter Replacement Cartridges
I have a Pentair that requires 4 cartridge - 20" tall 7" dia and hole opening 3". the fliter unit is not marked so i do not have a unit number to identify what system i have. this is the first cartridge i found with same size - question if they do not fit can i return them? I will not get them wet - simply place inside to check.
Second question - i am looking for a cleaning hose to fit the intake hole - male end one and one half inch. female end can be pluged by 1 1/2 inch male
Yes you can return these within 30 days as long as they are in new and unused condition. I'm sorry we don't carry the hose that you described.
I clean my pool filters with a pressure washer at an 45 degree angle at low pressure. Works extremely well but a lot of white water comes out during the process . Is this the filter coming apart ? And or the white water is from debris . Looking for advice.
Hello Bob- Yes, that is the cartridge being damaged and coming apart. I wouldn't use a pressure washer even at low pressure.
Will this cartridge take the place of Pentair P/N 178585 or R173578. Thanks
Hi Jeff, The 178585 and R173578 are used on the Pentair Clean and Clear Plus 520 so you will need the PL0121 Clean & Clear Plus 520 Replacement Cartridge.
My filter is P/N 188592 I would like to know if this is the correct replacement for the current filters. There are 4..Thanks
This filter looks to be the correct size, but want to make sure it will replace my current filter. Numbers on the filter are P/N 178580/R173873.
Hello Charlie- The Clean & Clear Plus 80 Generic Cart. (PCC80) - PL0119 is the correct generic replacement cartridge for your Filter.
Will this fit the Pentair R211084K canister. I am using the canister in a filter system.
If it doesn't fit that one, what filter cartridge will?
if this catridge feet in my purex triton clean &clear plus cc320p
Porfirio, The Clean & Clear Plus 80 Generic Cart. (PCC80) part #NFC1976 will fit you cc320p.
1 to 2 hrs
Screwdriver, Socket Set
My filter housing has 4 PCC80 filters.
I turned off the power to the pump, verified with a meter that the circuit was disconnected. Relieved the pressure from from the filter housing.
The fitting at the top of the tank turns 1/4 turn to remove the pressure.
Removed the clamp down bolt on the side of the tank. I opened the top of the tank. cleaned the O'ring seal. Drained the remainder of the water from the tank by removing the bottom fitting.
Removed old filters and cleaned all residue from inside the talk. Installed 4 new filters, replaced top fitting which holds the filters in place. Lubricated the O'ring with a silicone-based grease.
Replaced top of filter housing and installed the clamp and tightened the bolt assembly. While tightening, tapped the clamp with a rubber mallet to ensure a good seal.
Filled the pump housing (primed) with water. Turned power back on and started pump. No leaks!!
The old filters were over 5 years old and were cleaned semiannually.
Less than 1 hr
Having cleaned my original filters over and over, I still was not getting adequate flow. Obviously they had become too dirty and had to be taken out of service. Ordered a new set of PCC80 filters from INYOPools and replaced the originals. Wow! can't believe how much flow improved and how sparkling clean my pool looks now!
Less than 1 hr
Had restrictive flow into pool, had just cleaned about 3 weeks prior and had already needed cleaning again. Pool was clear. Took band off clean and clear plus 320 filter and removed old cartridges. Inserted new cartridges for Inyopools and wooked like a charm. Fit perfectly.
4 to 8 hrs
Socket Set, Time
- First-time pool owner since 2015.
- Very diligent in cleaning the pool filters. The old filters looked good and looked to be in good condition.
- I began to notice a lot of debris floating in the pool. I knew it was more than prior years and therefore cleaned the filters multiple times over a couple week period.
- Within a day or two, the floating debris would return.
- My first thought was that the pool filter was too small for my pool. I verified with the manufacturer that the filter was more than adequate for my size pool.
- Unfortunately, his suggestion was to clean the filters not to replace them. After a few more weeks I received an email from Inyo Pools that had a 4 pack of filters at a decent price. I ordered the new filters and the problem was solved.
Less than 1 hr
(5 out of 5 stars) Replacement cartridge
Reviewed By: Flyboy from Tucson, AZ ()
Pros: Fast, friendly, helpful service, good quality and fit
Cons: Freight costs
Product came individually packaged which made it nice if I did not want to change-out all four of the filter cartridges at one time. Quality of the filter is good, and the fit in my filter housing was perfect. Excellent service.