Part # 3109-0
Manufacturer Code SP1106
Alternate Part #'s SP1106, SP1106A, SPX1106
Vac Plate, SkimVac SP1081/1082/1084, 1-1/2" Straight - SP1106
I have an 8" Hayward skimmer plate 1 1/2" pool vacuum hose , but I need a 90 degree elbow swivel adapter for it also for the vacuum hose to fit properly in the skimmer & not be crunched up to work. Do you have such a part or a suggestion to solve this problem ? Thank You , Mark
The mfgr recommends the hose exits out the top of the skimmer, over the coping and into the pool. An elbow or kink will impact the vacuum performance.
It is better to go straight out the top of your skimmer so your vacuum hose is not compromised.
The mfgr recommends the hose exits out the top of the skimmer, over the coping and into the pool. An elbow or kink will impact the vacuum performance. Damage to the weir door and skimmer can happen if you are exiting thru the weir door.
I have a skimmer and inside the skimmer I found a sticker with the number 08650-1403 etc. on the skimmer plate outside the number is SWIMQ WC27-92. Which vacuum plate is appropriate for me.
I have a hayward skim vac sp1068 what is the current skim vac that matches
I HAVE A PROBLEM WITH MY INGROUND SKIMMER BOX, SOMEONE PUT MY SKIM VAC UPSIDE DOWN AND IT HAS GOTTEN LOGGED IN THE SKIMMER HILE, HOW CAN I GE THIS OUT SO IT WILL NOT MESS UP THE SKIMMER LINE AND WOULD THIS CAUSE THE PRESSURE IN MY WALL JETS TO SLOW
Hello Keith, Depending on how it is stuck into the skimmer under the tile, turn off your pump and try reaching through where the weir entrance is and the other hand on the top of the skimmer and try getting a section of the Vac plate lip. Or you could back wash some of your water down below the skimmer to see if the pressure would release. Is your basket still in the skimmer?
(5 out of 5 stars) Excellent skimmer plate
Reviewed By: Shelby T. from Louisa, VA ()
Pros: Very durable plastic with a rubber seal.
This item is exactly as shown and works great. It is an exact replacement for the skimmer plate. Even though it has the number SP 1106 on the package, it is really number SP 1106A.It is made of a strong plastic and fits perfectly on the skimmer for a strong vacuum seal.
(5 out of 5 stars) This replacement part was exactly what I needed. Fast service.
Reviewed By: Kay C. from Hot Springs, AR ()
I replaced my worn skim vac. Make sure you match your skimmer model number to the correct skim vac. I didn't realize this until I started searching. If you don't have the skimmer number, your old skim vac should have a number on it. Also didn't realize I am supposed to vacuum with the basket in the skimmer. Catches large particles. Whatever you do, replace worn equipment and enjoy you pool more.