Part # PL1592
Alternate Part #'s 336578, 5028003000, AC81876, NEP6370, PO12728SA
Pureline Pool Pump Shaft Seal Assembly
Compatible with the Following Above Ground Pool Pump Models:
Commonly Used on the Following Inground Pool Pump Models
Commonly Used on the Following Above Ground Pool Pump Model #'s
Commonly Used on the Following Inground Pool Pump Model #'s
Disclaimer:
All manufacturers’ names, brand names, trademarks, images, symbols, descriptions, and part numbers are used herein for reference purposes only.
can you help me locate shaft seal for my pump
Reply
I can help you with this, I just need the model of your pump. If you don't have any of that information, you can attach a picture of your pump to this email and I can identify it that way.
Reply
Which way does the steel washer end fit into the pump?
Reply
Chester, The "spring loaded" portion in the photo is facing upwards. When it is installed on the impeller, the part that looks like a steel washer, would be facing the impeller. For further reference, please refer to our How To Replace a Pool Motor Shaft Seal Guide.
Reply
I am looking for shaft seal and impeller for stark usa pump 75039.Thr axel is around 1/2".I cant find it Regards Per Inge
Reply
Hi You would require this Stark Shaft Seal and this Stark Impeller
Reply
Hello, is this seal PO12728SA the correct one for a Stark USA model 75117 pump that is leaking water between pump and motor? Thanks!
Reply
Yes, this is the correct shaft seal for your model Stark pump.
Reply
I have a Starke 2.0 HP Pump Model PR200XSI-US. Will this shaft seal work? If not can you recommend where I can get one that will...definitely leaking at seal.
Reply
Yes, this seal will work for a Stark above ground pool pump.
Reply
Less than 1 hr
Screwdriver, Socket Set
I disconnected the pump from power. I removed all the bolts from the motor to the housing. The two halves in the videos I've seen were to pull apart. Granted, my pump was not in the videos but I did what I thought would work. At first, I could not pull apart the two parts and had to give it some elbow grease. I gave too much elbow grease and pulled them apart. unbeknownst to me the two parts inside were connected by pins and when I pried both apart it broke the pins from the housing. So much for DYI, I had to purchase a new pump.
