Is the salt included with the salt chlorine generator?
Reply
No, salt is not included. You would purchase the salt locally and the quantity will depend upon the number of gallons of water in your pool. Use a salt that is at least 99.8% pure NaCl. The preferred salt is evaporated, granulated, food quality, and NON-iodized. Avoid using salt with anti-caking agents like sodium ferrocyanide, also known as yellow YPS (prussiate of soda). These cause some discoloration of fittings and pool surface finishes. DO NOT use calcium chloride.
Reply
I have an aqua logic system which is about 8 years old. The display on the wired panel has gone. I either need to replace the unit or the motherboard. How do I identify what system it is, the PS 4, 8 or 16
Reply
All of the various AquaLogic systems will use the same Aqualogic MotherBoard or PC Board shown here. You can go out to your power center to count how many relays you are using to determine what sized system you would require.
Reply
I have an Aqualogic AQL-PS-8, how do I know what rev # is installed?
Reply
Larry, The most accurate way to tell what REV you have on your Aqualogic AQL-PS-8 would be to call Hayward at 908-355-7995 with the serial number of you unit, which can be found on the inside of the door on your panel.
Reply
I have a " Chlorinator off High temp" message. Not sure what this means.
Reply
Hi, "Chlorinator Off High Temperature’ means the current chlorinator cycle has been interrupted due to a cell temperature reading of more than 140°F." If the water temp is not at 140°F, then you will need to replace the turbo cell.
Reply
I have an Aqualogic automation and chlorinator and need a user manual. Where do I find the model number to order one?
Reply
Hi, Frank. Here are the links to the Aqua-Logic Installation Manual and Aqua-Logic Operation Manual.
Reply