I have a twist lock plug on my filter. I am assuming that you can plug in this type of plug into the timer? Also my filter is a 1.5 HP and the specs say it is good for 1 HP. Can I use this or is there another model that will work?
Reply
This timer is designed specifically for pumps with a twist cord, however it can only handle pumps up to 1.0 HP. We do not have a timer available for twist lock pumps over 1.0 HP.
Reply
I have a 1 1/2 HP Hayward filter, I need a timer box that I can connect to it. Will this handle it or do you have another timer that might?
Reply
This will only accommodate up to 1.0 HP pump. If this is for an above ground pool pump then you could use the following timer SP1500FT http://www.inyopools.com/Products/02200022032590.htm
Reply
Is the the plug or the receptacle twist lock?
Reply
The recptacle on the timer is designed to accept a twist lock plug and the plug coming off of the timer is also twist lock. So both the receptacle and plug are twist lock.
Reply
Can this timer be mounted to a wooden receptacle post?
Reply
According to Intermatic, the P1131has a keyhole on the back which will allow it to be mounted to a post with a screw or nail. They recommend mounting the timer at least 1 foot above any standing water or snow.
Reply
What is the voltage range for this timer? I have a 1 hp Haywood pump for in-ground pools with a twist lock that is 220V, will this operate in this voltage range.
Reply
Hi, This timer is rated at 20 Amp, 120 volts, it will not be able to operate your current pump. We do not have a Plug-In Timer that will operate a 220 volt pump.
Reply
I need a timer that will work with a 1.5 hp and 15 amp would like a plug in .if i can get one
Reply
If this timer does not fit my current plug or outlet can I return if for a full refund?
Reply
Hi Dan, Yes you may return if it is in like new condition, you would just be responsible for any of the shipping charges.
Reply
