Model # AQL-WW-P4
The Aqua Logic System has 4 different control options available.
1. Wall Mounted Wired Remote - The wired remote requires 4 conductor wire to be run from the equipment pad to the location in the house where the Wall Mounted Wired Remote will be hooked to the wall. You can Add Up to 3 Wired Remotes to your Aqua Logic system. If you are adding the Aqua Logic to an existing pool, the wireless remote may be a better option.
2. Wall Mounted Wireless Remote - Aqua Logic wireless remotes require a Wireless Base Receiver. Only 1 Base Receiver is needed to operate any combination of 4 wireless remotes. The Wall Mounted Wireless Remote does not require any connections from the remote to the equipment set. This makes the wireless option ideal for retrofit applications. Unlike table top wireless remotes that can be moved around the house, this unit is mounted to the wall and plugged into a power outlet nearby.
3. Wireless Table Top Remote - This portable display/keypad with rechargeable batteries allows the homeowner to control the system from anywhere around the pool area or inside the house. Designed for indoor or outdoor use but must be protected from direct rain contact. Only 1 Base Receiver is needed to operate any combination of 4 wireless remotes. The Table Top Wireless Remote does not require any connections from the remote to the equipment set. This makes the wireless option ideal for retrofit applications.
4. Wireless Spa Side Remote - A Base Receiver is required when using the wireless Spa Side Remote. Only 1 Base Receiver is needed to operate any combination of 4 wireless remotes. Control up to 6 functions in the comfort of your spa with the Wireless Spa Side Remote.
Click Here for Wall Mounted Wired Remote Owner's Manual
Click Here for Wall Mounted Wireless Remote Owner's Manual
Click Here for Wireless Spa Side Remote Owner's Manual
Click Here for Base Reciever Owner's Manual
Click here for more Aqua Logic
My AQL-WW-P4 loses sometimes an hour every 6 hours, sometimes it's fairly close, what's wrong?
Hi, Dennis. The issue could be the Main PCB are experiencing the same issue. If just the inside wall unit is losing time then the wall controller is going bad. Replacement parts are not available so you will have to replace it.
My red light comes on saying low salt, but I have had the salt level tested and the numbers are correct. Been told the cell is reading wrong and the cost to replace the cell is $600. Would I not be better and less expensive to just replace the entire computer?
No, not necessarily. You may need to just replace the cell so I would recommend having the cell tested first at a local pool retailer. If it is showing as bad then that should be replaced first.
Hi now i'm getting error Check system no cell power 2....What does that mean and how can I fix it?thanks
Hi my wall mounted wired control ,the little arrow on the right side of the menu button isn't working,you think it's the panel or the card?Also my control outside in the box the led display is not showing anything,control or card ?Thanks
Hi Georges, Based on the fact that you are having issues both at the indoor remote and at the outdoor power center it leads me to belive that your issue is the Aqua Logic PC Board. Please make sure you have the Aqua Logic Control system and not the Prologic Control System as they look very similar. If you do have the Pro Logic then you will require the ProLogic PC Board.