Our remote has the AQL-TW-RF-PS-8 but not an AQL2. There is also the barcode
1R0605-1079755. Do you have a remote to work with our base or will the
AQL2-TW-RF-PS-8 work with it?
Reply
Hi Dan, The AQL2-TW-RF-PS-8 may not work because of the firmware, you will have to contact Hayward at 908.355.7995 to see what you'll have to do since the AQL-TW-RF-PS-8 are no longer available.
Reply
Lately, our salt level readings appear to be incorrect. One day it reads 3200 then changing to "low salt level" indicating 2700. Salt added, and level returns to 3100. Confirmed with Leslie Pool water sample. Later in the day, the light comes back on indicating "low salt". What causes this kind of behavior?
Reply
Hello Dick, when the salt is too low the AquaLogic generate less chlorine and the life of the cell is degraded. Check the cell and clean if necessary (see instructions, page 29) before adding salt (see instructions, page 26). Attached is the manual
Reply
Does this wireless remote require an antenna?
Reply
Hi, Jake. This Aqua Logic Wireless Wall Mount Remote does require the Aqua Logic Wireless Remote Base - AQL2BASERF.
Reply
Does this replace AQL-TTW-RF-PS-8?
Reply
Hi, Marice. This product will replace AQL-TTW-RF-PS-8 your Pro Logic controller and or Aqua Logic PS controller has an operating with software revision r2.00 or higher and using an AQL2-BASE-RF Base Station operating with software revision r3.00 or higher.
Reply
I have a new Hayward AquaPlus controller that was installed last year as a part of our pool installation.
What would I need to be able to control my lights and pump with this device?
We do not have a heater.
Hi, Jay. You will need the Wireless Base Receiver - AQL2BASERF.
Reply
Can I buy just the charger for the unit? It is a goldline AQL-TW-RF-PS-8
Reply
I have ps-8 .remote. Batteries will not hold a charge. W UT at hind of batteries do I buy? After unit is automatically turned off by timer it keeps trying to do MG e on
Reply