Model # AQL2WWRFPS8
By Goldline Controls
Model # AQL2WWRFPS8
The Aqua Logic System has 4 different control options available.
1. Wall Mounted Wired Remote - The wired remote requires 4 conductor wire to be run from the equipment pad to the location in the house where the Wall Mounted Wired Remote will be hooked to the wall. You can Add Up to 3 Wired Remotes to your Aqua Logic system. If you are adding the Aqua Logic to an existing pool, the wireless remote may be a better option.
2. Wall Mounted Wireless Remote - Aqua Logic wireless remotes require a Wireless Base Receiver. Only 1 Base Receiver is needed to operate any combination of 4 wireless remotes. The Wall Mounted Wireless Remote does not require any connections from the remote to the equipment set. This makes the wireless option ideal for retrofit applications. Unlike table top wireless remotes that can be moved around the house, this unit is mounted to the wall and plugged into a power outlet nearby.
3. Wireless Table Top Remote - This portable display/keypad with rechargeable batteries allows the homeowner to control the system from anywhere around the pool area or inside the house. Designed for indoor or outdoor use but must be protected from direct rain contact. Only 1 Base Receiver is needed to operate any combination of 4 wireless remotes. The Table Top Wireless Remote does not require any connections from the remote to the equipment set. This makes the wireless option ideal for retrofit applications.
4. Wireless Spa Side Remote - A Base Receiver is required when using the wireless Spa Side Remote. Only 1 Base Receiver is needed to operate any combination of 4 wireless remotes. Control up to 6 functions in the comfort of your spa with the Wireless Spa Side Remote.
Click Here for Wall Mounted Wired Remote Owner's Manual
Click Here for Wall Mounted Wireless Remote Owner's Manual
Click Here for Wireless Spa Side Remote Owner's Manual
Click Here for Base Reciever Owner's Manual
Click here for more Aqua Logic
What is the difference between AQL-TB and Wf
Hi. The TB is Table Top and the WF is Wall Mount. The WW is Wireless, FYI.
How to turn spa on
Hi. Once this remote has been successfully installed you can simply press the button assigned for the spa to turn on all the spa equipment.
Does this replace AQL-TTW-RF-PS-8?
Hi, Marice. This product will replace AQL-TTW-RF-PS-8 your Pro Logic controller and or Aqua Logic PS controller has an operating with software revision r2.00 or higher and using an AQL2-BASE-RF Base Station operating with software revision r3.00 or higher.
does this replace the aql tw rf ps 8?
Yes this AQL2WWRFPS8 will be the replacement for that unit.
Does this wireless remote require an antenna?
Hi, Jake. This Aqua Logic Wireless Wall Mount Remote does require the Aqua Logic Wireless Remote Base - AQL2BASERF.
Lately, our salt level readings appear to be incorrect. One day it reads 3200 then changing to "low salt level" indicating 2700. Salt added, and level returns to 3100. Confirmed with Leslie Pool water sample. Later in the day, the light comes back on indicating "low salt". What causes this kind of behavior?
Hello Dick, when the salt is too low the AquaLogic generate less chlorine and the life of the cell is degraded. Check the cell and clean if necessary (see instructions, page 29) before adding salt (see instructions, page 26). Attached is the manual
Our remote has the AQL-TW-RF-PS-8 but not an AQL2. There is also the barcode 1R0605-1079755. Do you have a remote to work with our base or will the AQL2-TW-RF-PS-8 work with it?
Hi Dan, The AQL2-TW-RF-PS-8 may not work because of the firmware, you will have to contact Hayward at 908.355.7995 to see what you'll have to do since the AQL-TW-RF-PS-8 are no longer available.