Model # UHXPOSHZ12501
Alternate Part #'s UHXPOSHZ12501, UHXPOSHZ12506
Indoor Pos. Pressure Horizontal 6" Vent Adapter Kit - H250FD
This kit enables indoor installation where the exhaust vent pipe termination is horizontal with stainless steel vent pipe and vent terminals available from Hayward or special ordered from M&G DuraVent Inc., or from Heatfab Division of Selkirk Corporation. This kit DOES NOT allow the use of galvanized, non-seals pipe.
I'm re-building a pool house (fire) and wanted the new 500k LP heater installed inside the building, what do I need to do now (venting, codes, clearance) as we are building as we I write
I notice this kit says it is for horizontal, on my heaters the exhaist is on top of the unit and goes vertical do I use the same kit or is there a vertical kit?
Hello, Just to be sure this vent kit uses 4" pipe and can be vented through a side wall horizontally? Also what are the clearances required once exiting the side wall and does it come with termination piece for the outside.
Hi, Pat. The H250FD vent kit uses 6" pipe for a horizontal or vertical venting application. The Termination is not included with the vent kit. The clearances requirements can be found on page 13 of the Hayward H-series LoNox Installation Guide.
(5 out of 5 stars) Excelllent pricing on Hayward
Reviewed By: Gopher Gold. from Knox, PA ()
Pros: Great variety of products
I was delighted to purchase this vent kit from Inyo. Another firm advertises it cheaper but after paying for one I was called that they couldn't provide it. If they don't have them I suppose they could give them away. Inyo plays no games. They were quick to respond to questions and courteous too. Unfortunately I didn't find them until after I had bought a heater elsewhere. Inyo would've been considerably less expensive.