By Jandy



Model # AQPLM

Alternate Part #'s JDY-30-0000, JDYAQPLM

Product Description

The Jandy AquaPalm/AquaLink Handheld Wireless Remote brings the power and flexibility of a wireless remote to new or existing AquaLink RS control systems with Rev "M" software or later. Designed to be the "must have" add-on, the AquaPalm allows remote control of your equipment in an attractive, waterproof and portable handheld.


    • Ultra compact, wireless, waterproof, handheld remote - it even floats!
    • Leading edge wireless technology offers a robust, reliable communication network for a flexible and simple installation
    • 500 ft. range of operation - does not require line of sight
    • Lower installation costs than a hard wired system
    • No wiring between the equipment and the control panel - that means no trench, conduit, or indoor wiring
    • Simplified Windows® style drop-down menus for control of filter pump, spa switch-over, heater, solar and up to 7 auxiliary circuits with the push of just one button
    • Personalized programming/labeling of all equipment and service information
    • AquaPure interface for control of on-site chlorine production
    • JandyColors pool and spa colored light interface for convenient color changing
    • Large backlit display of signal strength, battery charge, day, time, water temperatures plus complete equipment status
    • Powered by two AA batteries - average life, one pool season
  • *To upgrade to the PDA/Aqua Palm Hand Held w/18 Channel RF, R Kit - R0687300, AquaLink RS Systems must have Rev "M" software or later. If older, a new 52 pin PCB must be purchased.

?     Asked on 4/11/2007by Guest

What does this kit include?

A  Answered on 4/11/2007 by InyoPools Product Specialist Patrick P.

The AQPLM includes the hand-held controller shown above and a receiver.

?     Asked on 5/25/2016by W Kulesh

I have a spa included in my pool. How do I turn on "water fall" effect when not in SPA mode?

A  Answered on 5/26/2016 by InyoPools Product Specialist Lennox H.

Hi, If the waterfall is linked to the spa or uses the spa pump then it will have to be in "spa mode" in order to have the waterfall on.

?     Asked on 3/12/2017by Inyo Visitor

jandy remote stays on waiting. What to do to correct

A  Answered on 3/13/2017 by InyoPools Product Specialist Andy O.

Hello- According to the owner's manual for this unit, on page 18 it states: "Microprocessor locked.Turn off power to the system. Disconnect battery at the Power Center and turn on power. Reconnect the battery and reset time and date."


Review Summary

 (Average 0  out of 5 stars)
0 Rating
5 star:
4 star:
3 star:
2 star:
1 star: