Details

Top

Model # 009847

Warranty 1 Year

Manufacturer Code P-R266A-EN-C #52

Alternate Part #'s 009847, P-R266A-EN-C #52, RAY009847

Availability Please allow 3 - 4 weeks for delivery - Please allow 3 - 4 weeks for delivery

Product Description

This heater is used for altitudes ranging from 6,000' to 9,000'

BENEFITS:

  • Digital control with liquid crystal display (LCD) for temperature selection and heater settings

  • Capron resin headers prevent rust stains from harming pool surface

  • Plumb directly from provided 2" PVC threaded union

  • Smart microprocessor controls diagnostic read-out and continuously monitors operating status

  • Completely field serviceable

  • Small footprint

  • High efficiency

  • Guaranteed high wind reliability

  • Looks smart and works smart

  • 1 Year Warranty

  • Thermal Efficiency of 83% 

Warranty:


  

California Customers Please Note:  South Coast Air Quality Management District ( SCAQMD) Area of Jurisdiction REQUIRES a Low Nox Heater be installed.  The following 6 California Counties are affected:  Los Angeles, San Bernardino, Ventura, Orange, Riverside, & Kern. Installing a non-compliant heater in these counties will void the manufacturer's  warranty and could result in a fine from your local code enforcement.   

Product Specifications

BTU:
266,000 BTU
Ignition:
Electronic
Elevation:
6,000 - 9,000 ft.
Heater Type:
Natural Gas
Heat Exchanger:
Copper
Manufacturer:
Raypak
Top

?     Asked on 1/16/2012by Guest

Will a gas heater operate at the low speed of a dual speed motor?
 Reply

A  Answered on 1/16/2012 by InyoPools Product Specialist Patrick P.

Probably not - Most gas heater will shut off at low GPM levels (20-40) to keep the heater cores from overheating - 20 for 200 BTUs, 40 for 400 BTUs. Depending on your pool system you might get these GPM levels at the low speed but generally these heaters must be run at the motor's high speed.
 Reply


?     Asked on 3/24/2015by Dan

We are putting in a salt water pool that is 22000 gallons, would it be better to get polymer or cast iron headers, and would 266k BTU's be adequate?
 Reply

A  Answered on 3/25/2015 by InyoPools Product Specialist Robert M.

Hello Dan - Both the polymer and cast iron headers are designed for salt water. The cast iron headers are only required for commercial applications. For salt water. we would recommend a heater with a cupro-nickel heat exchanger. We would recommend the Hayward 300,000 BTU. This heater would require a high elevation kit if you are above 2,000'.
 Reply