$151.58
By Pentair Pool Products
Part # 6273-0070
Manufacturer Code 472363
Dimensions 14.25" L x 4" W x 2.5" D
Alternate Part #'s 472363, 47-110-1624, PEN472363
INYO # 6272-0070 PENTAIR # 472363 GENERAL DESCRIPTION: THIS IS THE FRONT HEADER TOP SUB ASSEMBLY USED IN THE MINIMAX CH & NT HEATERS THE COMPLETE HEADER IS MADE OF THE TOP SUB ASSEMBLY AND THE BOTTOM SUB ASSEMBLY THIS ASSEMBLY HAS 2 OPENINGS ABOUT 1-5/8" IN DIAMETER WHICH ATTACH IT TO THE BOTTOM SUB ASSEMBLY EACH OPENING HAS 2 O-RINGS, EACH IN ITS OWN GROOVE ON THE OUTSIDE OF THE OPENING WHICH SEAL THE CONNECTION POINTS THIS IS MADE FROM IVORY COLORED PLASTIC LENGTH: APPROXIMATELY 14-1/4" FRONT TO BACK: APPROXIMATELY 2-1/2" HEIGHT: APPROXIMATELY 4" THERE ARE 9 HOLES IN THE TOP SUB HEADER TO MATCH THE HEATER TUBES AND 8 HOLES FOR THE MOUNTING BOLTS ASSEMBLY INCLUDES: BOTTOM SUB HEADER WITH O-RINGS (4 O-RINGS TOTAL) MARKINGS: NO MARKINGS
Hi,can i buy o ring set for 472363 (two brown,two black).Please let me know what part number is that.
Thank you.
Martin.
Reply
Hi. Unfortunately, those o-rings are not available as a separate replacement part.
Reply
Is this unit new or old?
Reply
Hi Dr. Will this is new.
Reply
This part goes on my old Pentair Mini Max 400 NT LN jacuzzi/pool heater. It looks like the manifold was broken/cracked during original installation allowing a slow leak which, over time, eventually rusting nearly all the way thru the tungsten bolts on the right side - idiots! I will also need the gaskets/seals that couple the "In/Out Top Sub-Header Assembly" (472363) to the heat exchanger. I assume this "sub-assembly" includes all necessary grommets, gaskets, seals, washers & o-ring's - yes?
Reply
Hi Dr. Will, I'm sorry to hear that. This is just key #19 as shown in this Pentair MiniMax NT Parts Diagram if you need the complete assembly then please take a look at key #20 on the parts diagram. If you determine you need key #20 then you may view or purchase that item here Pentair Minimax NT Main Header Assembly
Reply
