Part # 4890-049
Manufacturer Code V34-021
Dimensions 0.75" L x 0.05" W x 0.05" D
Anthony Spring Pin - V34-021
In the middle of the shaft is a hole - I am guessing for a pin - like there is just under the handle. I haven't seen it on any charts - their second pin is closer to the top of the shaft. The hole in the middle of the shaft is a little larger - maybe 2/16? - than the one under the handle. Will this pin work? Is it even necessary?
And when the description says 1.5 or 2 inch, is that determined by the diameter of the plunger at the bottom? Thank you for any help.
Reply
Hi, Karen. This Pin will work if you have the Anthony Bronze Push Pull Valve and it is necessary for the valve operation. The 1.5 or 2 inch description refers to the valve plumbing size.
Reply
More than 8 hrs
internet / charge card / vise / hard plastic hammer
1 0
Needed tension pin replacement. Rec'd correct catalog part.
Tension pins delivered too small for 1/8" holes in plunger...
Needed replacement - copper or stainless, but couldn't find locally.
Ordered pins from McMaster-Carr and got pins (albeit quantity 50) that did the job.
