Unitension Wire (79110400)

$41.99

IN STOCK
FREE SHIPPING

Part # 3525-14

By Pentair Pool Products

  5 Average  

Details

Top

Part # 3525-14

Manufacturer Code 79110400

Dimensions 10.25" L x 10.25" W x 0.5" D

Alternate Part #'s 79110400, AMP3011231, 57-110-1122, PEN79110400

Product Description

Unitension Wire

Top
Difficulty

Est. Repair Time

Less than 1 hr

Tools Needed

Screwdriver, Pliers, Wrench Set

2     0

Lens did not completely seal due to old misshaped wire.

Written on 11/12/2020 by Guest

Since I was in the middle of emptying the pool due to chlorine lock, only using 3" chlorine tablets for past eight months, I decided to repair the pool light, water leaked into light shorting the circuit and causing GFCI to trip, did not replace gasket last time I replaced bulb, my bad. Before tackling the job find a few videos to watch to help visualize how to do it!
1. Emptied pool, only because I had to for another reason, there is no need to empty pool to repair the light, the cord should be long enough to put the light on the deck.
2.Turned off breaker to pool electrical and removed light to pool deck
3. Using a 3/8" wrench for bolt head and 7/16" wrench for nut removed retaining ring
4. Used flat blade screwdriver to loosen seal and separate lens gasket from light housing
5. Carefully unscrewed bulb, bulb had hole burned through at base
6. There was corrosion and rust in socket so poured CLR into socket and let soak for 15 minutes rinsed with water, towel dried and left it in the sun to dry for three days while I did tile repair
7. Inspected socket, then using electrical contact burnishing tool to remove oxidation on the bulb contact, installed new bulb, turned on breaker to electrical, turned on light for a few seconds to insure light worked
8. Removed old gasket from lens and cleaned lens
9. Installed new gasket on lens, the gasket is the same on front and back so just install it on the lens
10. Replaced badly misshapen retaining unitension wire, put light housing on the deck with the bulb facing up, put the lens with gasket on housing being sure to center it and make sure half moons on lens are pointed toward bottom of light, place face ring on gasket being sure to center it, make sure the retaining clips are evenly spaced around face ring, place the unitension wire on the clips with the bolt loops facing down, put the bolt into the loop pull loops together with channel locks install washer and nut. Tighten nut until loops touch
11. Install light into pool housing putting slot on bottom of light over the retainer at the bottom of the pool housing, push light flush with pool wall and install the single screw at the top.

Were these instructions helpful? 
 

Top

Review Summary

 (Average 5  out of 5 stars)
1 Ratings
5 star:
 
(1)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)

The Most Recent Reviews