Part # 7060D

Alternate Part #'s AQP7060D

Product Description


*Older models that have 3-Pin connector on the cable will require the Plug, Aqua Products, Male, 2 Pin/2 Wire, For Flat Cable - A1615PK for installation to the new power supply.

Commonly Used On

  • Aquabot Junior
  • Aquabot Classic
  • Aquabot Xtreme

?     Asked on 5/27/2016by Willy

I am intrested in the power supply switch only for the classic Aquabot. It was a very weak to begin with and it came apart over this weekends use. Thanks Willy

A  Answered on 5/30/2016 by InyoPools Product Specialist Alex V.

Willy, Unfortunately, we don't carry parts for the power supply. You will need to contact Aqua Products to see where you can source one.

?     Asked on 6/21/2016by Inyo Visitor

I bought two fuses for the Aquabot junior from you recently and both popped immediately on implementation. order # 61CA394-1, po 635491. Can you check there was little information included with the items so I believe they were not the right item. What can we do about this. I work in Windsor and could come by tomorrow if that's an option

A  Answered on 6/26/2016 by InyoPools Product Specialist Lennox H.

Hi, The Fuse you order is not specifically for the Aquabot Power Supply 7060D, the Generic Mini 2.5 Amp Slo-Blo Fuse is the correct fuse for this power supply.

?     Asked on 6/29/2016by John Hoffman

quabot classic power supply fuse T3 15A 125V The fuse is blown and I want to buy a replacement. Where can I get this fuse?

A  Answered on 7/4/2016 by InyoPools Product Specialist Lennox H.

Hi John, The OEM Mini 2.5A, 250v, Slow-Blow Fuse (7207), or Generic Mini 2.5 Amp Slo-Blo Fuse (001-1020) can be used with this Power Supply (7060D).

?     Asked on 7/29/2016by Inyo Visitor

I purchased a classic in-ground robot cleaner but it came with no power supply where do I get one with a timer that's not over 500.00.

A  Answered on 7/31/2016 by InyoPools Product Specialist Lennox H.

Hi, There is not a power supply with timer that is compatible with the Aquabot Classic cleaner.

?     Asked on 6/10/2017by Tom

will this replace Auqaproducts T2-36 3 male prong power supply

A  Answered on 6/22/2017 by InyoPools Product Specialist Lennox H.

Hi, Tom. The correct power supply for the Aquabot T2 unit is p/n 7184C.


Est. Repair Time

1 to 2 hrs

Tools Needed


3     0

Existing power supply stopped working - and was not able to be repaired

Written on 6/26/2019 by Guest

Electrical wiring was toasted- so it was easier to replace it... I had contacted a few companies but INYO was the first to respond and respond correctly. Even though the product was slightly more expensive than a competitor I decided it was best to get it from the one company that was able to provide me with the fastest and accurate response.
Time is money!

Were these instructions helpful?