$599.00

Qty:

By Pureline


Details

Top

Part # PL1116MKITASSY

Alternate Part #'s SPX2603Z1VSPE

Product Description

Pureline 1.65 HP Power End Motor Assembly for Hayward Super Pump (PL1116MKITASSY)

Upgrade your Hayward Super Pump effortlessly with the Pureline 1.65 HP Variable Speed Power End Motor Assembly (PL1116MKITASSY). This all-in-one replacement kit includes everything needed to swap out your old motor quickly and efficiently—reducing what’s typically a 90-minute job to just 15 minutes.

Complete Assembly for Easy Installation

This kit includes:

  • 1.65 HP Motor – Powerful and efficient replacement
  • Mounting Plate & Seal Plate – Secure and durable design
  • Impeller & Diffuser – Ensures optimal water flow
  • Shaft Seal & Gaskets – Prevents leaks for long-lasting performance
  • Bolts & Hardware – Everything needed for a hassle-free install

Quick & Simple 6-Step Installation

  1. Turn off power
  2. Disconnect motor cables
  3. Remove bolts and slide out old motor assembly
  4. Slide in new PL1116MKITASSY assembly and tighten bolts
  5. Reconnect cables
  6. Turn power back on

Skip the hassle of sourcing individual parts—this pre-assembled kit simplifies motor replacement so you can get your pool pump running again in minutes.

  • Compatible with Hayward Super Pump models
  • Built for durability and efficiency
  • Perfect for DIY pool owners and professionals alike

Upgrade today with the Pureline 1.65 HP Power End Motor Assembly and experience the fastest and easiest way to restore your pump’s performance.

* This can replace the SPX2603Z1VSPE. However, it will not fully communicate with a Hayward automation system (OmniLogic, ProLogic, etc.). The Hayward automation would only be able to turn the pump motor on/off.

 

Product Specifications

Amps:
7.0 - 1.0 amp
Flange:
Round
Frame:
56J
HP:
1.65 HP
Manufacturer:
Pureline
Service Factor:
1.1
Speed:
Variable
Volts:
230 V
Top

?     Asked on 5/19/2025by WILLIAM COOPER

Question about the Pureline 1.65 HP Pend Motor assembly. What is the width of the controller mounted on the top of the motor. I have very tight clearance between my sand filter and the existing motor and want to make sure it fits. You provide the total length of the motor at 17 inches but I need the width of the top
 Reply

A  Answered on 5/20/2025 by InyoPools Product Specialist Robert M.

The widest point of the control is 9". The height measurement from the top of the motor to the top of the control is 5".
 Reply


Top

Review Summary

 (Average 0  out of 5 stars)
0 Rating
5 star:
 
(0)
4 star:
 
(0)
3 star:
 
(0)
2 star:
 
(0)
1 star:
 
(0)