The gasket fits perfectly, but it sticks out about 1/32 of an inch. Is this normal? most gaskets seat flush against the housing....TY
Reply
Hello Frank- This gasket in particular sticks out just a bit when installed. I know it'll seem unnatural but I can assure you its been that way on every super pump I've worked on.
Reply
I bought kit #23. It seems like the seal is to big for the seal plate. It does not fit snug at all. I assume it goes on the outside of the seal plate, then goes into the filter. Could it be to big?
Reply
Bill. Kit # 23 does not include this gasket. The Housing Gasket fits into the grove on housing. Make sure you have the correct parts.
Reply
Is this the only gasket I need if replacing my motor on Hayward Super Pump ?
Reply
Most commonly we recommend getting the complete seal kit which for the Super Pump can be either the GOKIT3 for a chlorine pool or a GOKIT3SALT for a saltwater swimming pool.
Reply
Where does this gasket go?
Reply
Hi, Joe. This Housing Gasket - G-95 goes into the pump housing. You can use the Hayward Super Pump VS Parts Diagram as a reference.
Reply
I don't see how this part is supposed to fit. Should it lay flat between the pump housing and the defused? So, you you'd rwistmit half a turn to make it lay flat? Or does it just crush down flat when you tighten the 4 bolts?
Please refer to our How To Replace Pool Pump Gaskets http://www.inyopools.com/HowToPage/how_to_replace_pool_pump_gaskets.aspx about 4-minutes into the video we review replacing this type of gasket.
Reply
