I have removed this pump from my Jucuzzi tub that is being scrapped. Can it be used to move water from flooded areas around the house? Heavy rain usually collects in low spots around the house and a high volume pump would be helpful.
Reply
No, the pump needs you to describe should be of the submersible design.
Reply
I currently have Gemini Plus Pump Series
A076E00C R125A-C
1 V15XT
120 10.5 50/60 CL-B
Current pump is a replacement for the original with the whirlpool tub. I bought the current one locally years ago. It is beginning to squeal and I assume is a sealed unit.
Bottom line. Is the Gemini 11 Plus Pump the current replacement for what I have?
Thank you
Reply
It is a couple of amps lower, but I doubt it will make much of a difference in your application. The wet end is the same, so no plumbing issues. Depending on how the original is configured, you may need to reuse existing cord from the original, installing it on the replacement. As far as the air switch is concerned, if it is not needed in their current application, it will need to be bypassed.
Reply
Yes this Gemini Plus ll is a good choice
Reply
I have an ITT Marlow Gemini Plus 3/4 HP bath spa motor. Spec #0002C00C. It is 10.5 amps, 120 V (one phase). What is the current replacement model and specs?
Reply
34-109-1040 is the correct replacement but will have a slightly higher amp rating of 12.5
Reply
What is the horsepower of this item? Thanks, My broken unit does not show HP, but is 12.5 amps, 120v, -Model NR4AC- part number 0060F88C-S/n 0060F88c1011300042 on the motor. If I have 1 hp should I go up to 1.5HP? there are 6 jets total.
Thanks
EARL C
Reply
Hi, Earl. This Pump is approximately 1.5 HP. Increasing the pump HP can cause issues if not properly sized.
Reply
